0
More than likely your carb is dirty from sitting to long, you probablly have to choke it to keep it running which means the slow jet is plugged, take carb off and clean and kit it. Be sure to put a clear two dollar in line fuel fiter between the carb and the tank. I have two 200's and one 350 and all three bikes had to have the carbs cleaned !!!
What else can I help you with?
What carburetor is on a 1999 Yamaha big bear 350?
Mukini
Did Yamaha make a 350 big wheel?
Yes, Yamaha made an 80, a 200, and a 350 Big Wheel.
I cleaned my carburetor for my Yamaha bruin 350 now when you give the gas it stalls.It will idle. what did I do wrong?
If the carburetor is cleaned on the Yamaha Bruin 350 and it will idle but stall when given gas, it could be that the float is sticking. The carburetor may also need to be adjusted by turning the adjustment screw so that it is not getting too much gas when revved.
How do you remove the carburetor on a 350 Yamaha ATV?
To remove the carburetor from a 350 Yamaha ATV, start by disconnecting the battery and removing the seat and side panels for access. Next, disconnect the fuel line, throttle cable, and any electrical connections attached to the carburetor. Loosen the clamps securing the carburetor to the intake manifold and carefully pull the carburetor out. Finally, make sure to note the positioning of any gaskets or spacers for reassembly.
What causes backfiring and poor idle on a 2004 yamaha raptor 660?
Poor upkeep try cleanig the airfilter if that doesent work try cleaning out the carburetor I have a yamaha 350 bruin I had the same problem
Is the 1997 Yamaha 350 Big Bear 4x4 all time 4-wheel drive?
yes it is
Yamaha 350 Big Bear 4x4 that has a tapping sound in the left front wheel area sometimes it squeaks any idea what this may be?
wheel bearing
What carburetor does a 1998 wolverine 350 have?
it has a 34mm mikuni carburetor.
Where is carburetor adjustment screws on 1988 Honda 350 foreman?
The 1988 Honda 350 carburetor adjustment screws are on the side of the carburetor. There also is an adjustment screw on the very top of the carburetor.
Will a Yamaha 700 grizly wheel fit a 350 grizzly?
No, a Yamaha Grizzly 700 wheel will not fit a Grizzly 350. The two models have different bolt patterns, offsets, and sizes that make their wheels incompatible. Always check the specifications for the specific models and consult with a dealer or expert for the best options for your ATV.
350 Yamaha Warrior has how many strokes?
The Yamaha Warrior 350 is a 4 stroke.
Where does the hose go on the bar at bottom of a carburetor for 350 bigbear 97?
On a 1997 Yamaha Big Bear 350, the hose at the bottom of the carburetor typically connects to the overflow or drain line. This line allows any excess fuel or overflow from the carburetor to drain safely away from the engine. Ensure the hose is securely attached to prevent fuel leaks and maintain proper function of the carburetor. Always consult the specific service manual for your model for precise information.
