answersLogoWhite

0

This will take several steps to complete. You will need 10mm and 7mm sockets for your socket wrench. An open end wrench and socket extension will also be handy.

1) Open hood. Remove both headlight assemblies by removing 3 10mm bolts securing each headlight to the frame. Unplug the headlight bulbs and place the lights to the side.

2) Remove the 3 10mm bolts in front of the hood latch and set aside.

3) Remove the 2 10mm nuts found on each side, inside the space left by the removed headlights. You may need an open end wrench to access these bolts.

4) Remove the 2 10mm bolts found under the bumper on each side at the front of the wheel wells. You may need a socket extension to access these bolts.

5) Remove the 6 7mm bolts found under the bumper below where the headlight assemblies where mounted.

6) With these bolts all removed, the plastic bumper and painted place nose can be slide off the front of the car in one piece.

7) There are 5 10mm bolts joining the bumper and nose piece. These can be removed if you need to separate the two pieces.

8) Reverse these steps to reinstall the front bumper.

-Greg B.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove the front bumper on a 1994 jeep Cherokee 4 door?

behind the bumper, there are 4 bolts , 2 on each side.


How do you remove front bumper cover 1994 suzuki sidekick?

Feck off big hammer!


How do you remove front bumper from 1994 Intrepid?

Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.


How do i remove rear bumper on 1994 explorer?

The 1994 Ford Explorer rear bumper is held in place with eight retaining bolts. Remove the retaining bolts and the rear bumper will come off.


How do you remove a front bumper on a 1994 Acura Legend?

there are 4 bolts holding that bumper in place. 2 are accessible through the bumper itself, you may have to remove two square covers depending on the type of bumper. the other 2 are hidden behind the bumper turn signal lights, to remove the lights, you have to look under the light with a flash light and look for the screw holding that light in place.


Can a front bumper of a 1994 Ford Explorer fit a 1994 Mazda Navajo?

yes it will


How do you replace the front wheel bearings on a 1994 Saturn and what is the best way to remove it from the controller arm?

Remove u-joint clip (CV Joint), remove as an assembly, press bearing out.


How to remove 1994 Saturn front outer door handle to be able to remove outer door panel?

I don't know - but the question about the 1993 door handle is the same...


How can you reduce the weight of a 1994 firebird formula?

gut the bumper supports, gut the braces out of the doors, get lexan windows, remove the rear seats, get cloth front seats


How do you remove bumper on Dodge 1994 B250?

Unbolt it. Careful, it's heavy.


Where is the radiator located on a 1994 Chrysler New Yorker?

It is between the engine and the front bumper.


Where is the horn located on a 1994 Ford Mustang?

In front ofthe leftfront fender, behind the front bumper, andunder the splash guard.

Trending Questions
Where is the fuel rail pressure sensor on a vauxhall vectra 2.2 direct? How do you bleed the clutch line on a 1999 Dodge Ram 3500 with out a bleed screw on either end? Should you just buy a replacement panel rather than a whole new garage door for cracked top panel of garage door? 2005 Toyota Sienna low idle after replacing the battery? Where is the fuel pump relay located in a 1984 mercury cougar? What cars does a DW-4670 oil filter fit? How do you get a ls1 motor out of a mendeola transmission? 94 camera convertible the top doesn't wont to go down if i push the switch button to make it come up you can hear it working when i push it down i dint hear anything i test the switch and? Ford F-150 How many quarts of fluid in standard transmission? Does a 2005 Chrysler town and country van have a timing belt or timing chain? What distributor will fit a Honda civic esi 1.6 1995 model? How many miles to change a cambelt? Where is the Chrysler Concorde 3.5 air intake temp sensor? How do you replace the brake light switch on a 2006 Chevy Aveo? Why would the service engine light keep coming on even after you have had plugs wires fuel filter cam sensor and coilpack replaced? Where does the transmission fluid go in the Honda Passport? Why does the clutch on a 1989 205 GTI 1600cc slip and when it is floored just rev up even when your foot is off the clutch? What should oil pressure be for lsvtec? How do you adjust the carburetor on a 17.5 Briggs and stratton? How do you reset the check engine light on a 2007 Toyota Corolla?