in a 2005 800 the front outer is replaced by removing axle nut. brake caliper, rotor and boot. rest half shaft on jack stand. place large pipe wrench or adjustable wrench over shaft behind cv joint. strike wrench with a 2.5 pound hammer. cv joint can be easily disassembled and cleaned. use screwdriver handle to tap bearing cage verticle. remove bearings one at a time. rotating cage after each one. clean, rinstall and grease.
Polaris has its brand of hub oil , which is not cheap . Ford ATF :automatic transmission fluid is recommended if you do not want to pay for Polaris oil .
on top up engine. below fuel tank. usually has red rubber cover.
if its water cooled you have water in the oil ie; head gasket or liner leaking.
Do you need any special tools.
Cabela's Sportsman's Challenge was created in 1997.
how do u replace the lower ball joint on a 1997 ford mustang
no the balljoint can be removed
Nexus Polaris was created in 1997-08.
To adjust the idle on a 1997 Polaris Sportsman 500, locate the idle adjustment screw on the carburetor. Start the engine and let it warm up, then turn the idle adjustment screw clockwise to increase the idle speed or counterclockwise to decrease it until you reach the desired RPM, typically around 1200-1400 RPM. Ensure the engine runs smoothly at this setting, and make any necessary fine adjustments. Finally, check for any unusual noises or vibrations during operation.
Where is the main fuse located on 1997 Polaris jet ski
Cabela's Sportsman's Challenge happened in 1997.
with a u-joint press or c-clamp, there is a procedure, consult a repair manual, probably at your local library.