0
Replaced CV Joints now car runs and speedometer moves but why won't my car go forward or in reverse?
in some vehicles, two axles cannot be pulled out at the same time. part of the transmission drops down and causes the problem you have now. if the wrong axles were installed, your problem may occur. finally, if the inner joint was not installed completely into the transmission, your vehicle will not move.
What else can I help you with?
What joints can be replaced?
Permanently damaged joints can now be replaced by Artificial Joints
How often should ball joints be replaced?
Ball joints should be replaced anywhere between 70,000 to 150,000 miles. Ball joints connect the wheel to the car's suspension system.
Can ball joints be tighten or be replaced on a 2002 Chevy Venture?
ball joints cannot be tightened. if they re worn and have play in them, they need to be replaced
Eventually these soft spots are replaced by immovable joints called what?
Fontanelles are eventually replaced by immovable joints in the skull called sutures.
Which joints helps in moving head forward and backward?
The joints primarily responsible for moving the head forward and backward are the atlanto-occipital joints. These joints are located between the atlas (the first cervical vertebra) and the occipital bone of the skull. They allow for nodding movements, enabling the head to tilt forward and backward. Additionally, the cervical spine joints contribute to the overall range of motion in the neck.
Why does 95 ford crown Victoria make a clank noise when shifting into drive or reverse?
Have your u-joints checked on the drive shaft. Most likely need to be replaced. If that's not it, then check the slack in the diff.
If ball joints were replaced wouldn't cv joints also be replaced?
Not unless that was part of the original work order. These are two distinctly separate parts - especially considering the CV (constant velocity) joints are part of the axle assembly.
Can bad shocks make a popping sound while in reverse and the wheel turned you have a 2005 Dodge ram 1500 4.7 liter?
That is doubtful. It sounds like you have a 4x4 vehicle and the front CV axles (or U-joints depending on how it is set up) are bad. typically you can first detect the joints going bad when turning in reverse. After a while, you will begin noticing the popping while driviing forward and turning if not repaired.
How do you troubleshoot CV joints on a 95 Ford Aspire?
Take the car to a large parking lot and turn the wheels while accelerating moderately; with the wheels still turned, stop and do it in reverse. Listen for any clicking, knocking noise. By loading the bearings in forward and reverse a bad CV will usually make noise.
Why does my xk8 clonk from drive to reverse and vice versa?
Have you had your u-joints checked?
Will lower ball joints start squeaking when they need replaced?
Not typically.
Can you grease ball joints 1996 sable?
Factory ball joints do not have a grease fitting. If yours have been replaced, it is then possible it will have a fitting.
