The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.
Master cylinder brake lines are the most common brake lines on a the Chevy Malibu.
If you did not open any brake lines and only replaced the pads there is no need to bleed the system.
replace the line and fill and bleed breaks.
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
completely
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
3/16
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
It is probably the oil cooler lines.
The brake lines on a 96 Corsica can be fixed by replacing damaged sections with new lines. This will improve braking and prevent catastrophic failures.
there are two or three nuts under the steering colum pretty hard to get to disconnect the brake lines from under the colum and it should come right out replace and it should be all good i did it had know idea what i was doing but it went pretty easy
possible air in the brake lines.