0
What else can I help you with?
How to disarm your car alarm after installing a new car battery?
Insert the ignition key into the ignition and turn it to on, the alarm should shut off.
What if just the battery has been disconnected for an entire day would this still work?
it should, doesn't matter if battery is disconnected for 10 minutes or whole day
What is the first thing that should be disconnected when removing a fuel tank?
The negative battery cable from the battery.
Which color should be connected first when installing a new battery in a car: red or black?
When installing a new battery in a car, the red color should be connected first.
How do I polarize a 6 volt magneto?
To polarize a 6-volt magneto, first ensure the ignition is off and the magneto is disconnected from the battery. Then, briefly connect a jumper wire from the positive terminal of the battery to the ignition terminal of the magneto. This will send a small current through the coil, establishing the correct magnetic polarity. Finally, reconnect the magneto to the ignition system, and it should now be properly polarized.
If code 12 means the battery or computer has been disconnected how do you reconnect the computer?
Can you be more specific? Was your battery disconnected or did it lose it's charge? If you did not disconnect the computer, it would not need to be reconnected. If your battery was dead or disconnected, simply remove the positive battery cable for about 10 minutes and re-connect it. This should clear your code. Even if the code does not clear you should have no problems with the function of your car.
Car battery blow when starting car?
A car battery should never "blow" during normal operation. This can happen due to hydrogen gas ignition, loose or incorrect battery connections, overcharging from a faulty alternator, or an internal battery defect. If a battery explodes, it should be replaced immediately, and the charging system should be inspected before installing a new one.
How do you reprogram a 2005 focus after installing a new battery?
the computer should reset itself after you reinstall a battery. :D
After changing alternator how do you reset 98 gtp engine?
You do not have to reset anything. but you should have the battery disconnected. and once you reconnect the battery it will reset your computer.
Does engine require reprogramming after battery change on 2004 Toyota solora?
It might need reprogramming, but try this first.. 1. Disconnect the battery and leave it disconnected for 10 minutes. 2. Rehook the battery, then turn the igntion on without starting it. 3. Leave the ignition on for 1 minute, then try to restart it. It might take a while, but it should level out. Good Luck!!!
How do you re mobilize a 1996 range rover?
When my Rangie did this i disconnected the battery, put the key in the ignition and then reconnected the battery, this forces the key and immobilizer to re sync. failing that phone your dealer with the chassis number and they should be able to give you the code which you need to input using the key in your drivers door.. Hope this helps D
How do you reset 2004 pacifica?
To reset a 2004 Chrysler Pacifica, you typically need to disconnect the battery. Start by turning off the ignition and then disconnect the negative battery cable. Leave it disconnected for about 15 minutes to allow the system to reset. Reconnect the cable, and this should clear any error codes and reset the vehicle's systems.
