0
What else can I help you with?
Do brake drums need to be replaced after being saturated with brake fluid?
No, the drums can be cleaned with brake cleaner.No, the drums can be cleaned with brake cleaner.
How do you remove brake drums without a tool?
If you are inexperienced, you should not be messing around with the brake drums.
How are the brake drums and shoes replaced on a 1995 Camry V6?
Remove the wheels from your 1995 Toyota Camry. Remove the brake pads by removing the brake pad Springs. Tap on the brake drum with a hammer or mallet. Slide the brake drums off. Reverse the process to install the new brake drums and shoes.
How do you remove the rear brake drums on 1998 Pontiac sunfire?
brake drums should pull off if not rusted on.
What is replaced with brake repair?
Most often a brake repair simply involves replacing the brake pads. If the pads have worn too much though the rotors or drums will also need to be resurfaced or replaced. In more serious cases the master cylinder that controls the brake pressure will be replaced. Brake lines rarely if ever need to be replaced.
This is evidence that brake drums or rotors have been overheated and need to be replaced?
If the rotors have over heated you will get brake chatter. The pedal will shake when you apply the brakes. Usually the drums are a little tougher. The new rotors are very thin.
You replaced rear brake shoes and drums your brakes are now fading and have to be pumped to stop There are no leaks and the adjustment is up where it should be?
Try bleeding your brakes. If there is air in the system it can give a spongy feeling to your brake pedal and require you to pump your brakes and/or put your brake pedal to the floor.
What is air brake overhauling?
The only thing in an air brake system you'd really overhaul would be the compressor itself... the rest of it typically gets replaced. Valves, brake chambers, brake drums, brake shoes, etc.
Do your brakes have to do with your car making a grinding noise when you use them?
probably, if the pads are worn, or the rotors \ drums are scarred, there will be a grinding noise, plus you should be able to feel it through the brake pedal. most modern brake systems have quealers on the pads to tell you when they are getting worn and should be replaced. If you have a disc brake system, you should be able to inspect the rotors quite easily. Look for gouges in the surface of the rotor. If they are badly gouged, they should be turned or replaced.
Why does your brake pedal vibrate and a grinding noise when braking only when coming to a stop?
The brake pads or brake shoes are worn and rubbing against the rotor or drum, Disc brakes use brake pads and brake drums use brake shoes. Need to get them replaced before they cause too much damage or you will wind up with repairs or replacement of the rotors or drums also.
Does anyone know how long it takes to get your drum brakes replaced?
It is difficult to say for sure how long it will take to repair brakes. It is a tedious job and will usually take from 1 hour at the very least to 2 hours to remove the drums, replace the brake shoes and determine if the drums also need to replaced. If the drums need to be replaced, it can be a 3-4 hour job.
What does it mean when my jeep commander shakes while braking a high or low speeds?
Your brake rotors or drums are warped and need replaced.
