0
What else can I help you with?
How do you change the front lug studs on a 2000 Cavalier?
The brake caliper will have to be removed as well as the brake rotor. Then the studs can be hammered out. The new studs need to be pushed in as far as possible, then using washers as spacers the lug nut can be tightened up to pull the lug into place.
Lug nut torque for a 94 accord wagon?
The lug nut torque for a 1994 Honda Accord Wagon is approximately 80 ft pounds. It is important not to over tighten as the studs may break if mishandled.
2003 dodge ram 1500 lug nut bolt pattern?
5X5.5 (139) 1/2 studs
What is the lug nut torque for 1972 Chevy K10?
With stock rims and 7/16" studs, 75 ft lbs. With 1/2" studs, 90 ft lbs.
What would cause all 5 lug nut studs to break?
Most likely they are cross threaded because of the wrong thread pitch on the lug nuts. But could just be over torqued.
How do you replace the wheel studs on a 91 Honda Prelude?
They are pressed in the hub so you have to knock them out. I use an air hammer with a flat tip hammering bit. when you install the new studs you slide them in the hole then use an OLD lug nut and with an air powered impact gun, screw the lug nut on the stud until the new stud is pulled tight in the hub, you want it to look like one of the old studs. MAKE SURE there is no gap between the hub and lug nut on the back side of the hub. Then torque to specifications. wich i belive is 115 ft lbs. but dont quote me....
Lug nut size on Nissan 240sx?
The lug nut size for a 240sx with a four lug pattern is 10x1.25. The lug nut size is 12x1,25
What could cause an 1997 Acura RL to have 10 broken wheel studs while lossening the lugs and while driving?
lug nut were loose
How do you change out the lug studs on the front of your 1982 Chevy silverado 4x4?
you knock the studs out with a hammer and then you can put the new one in it will not go all the way in you use the nut to pull the stud back in all the way
How do you separate the hib from rotor on a 2005 silverado 3500 with dual rear wheels?
Take them to a machine shop and have the wheel lug studs pressed out. Or using a lug nut threaded onto the very end of the lug stud (to prevent stud damage) place a socket on lugnut and hammer the stud out. After all studs are removed the rotor and the hub will seperate.
What is the lug nut size for a 2007 Honda CR-V?
The Honda CR-V lug nut size is a 19 mm lug nut. The 2000-2002 size was a 21mm lug nut.
How do you replace wheel lug studs on a 1967 Newport Chrysler?
To replace the wheel lug studs on a 1967 Chrysler Newport, first safely lift the vehicle and remove the wheel. Then, remove the brake drum to access the lug studs. Use a hammer to tap the damaged stud out from behind the hub. Insert the new stud from the back, and secure it in place by tightening a lug nut onto the stud to pull it into position. Finally, reassemble the brake drum and wheel before lowering the car.
