motor shuts off when put in gear sometimes
The throttle cable and shift cable on a 1984 40 HP Mercury outboard engine is installed by raising the access panel and locating the appropriate connectors. Each cable is then attached to the engine to control its speed and gearing.
remove and reinstall
On a 1999 Mercury Tracer with a 2.0-liter engine, the throttle position sensor (TPS) is located on the throttle body. It is typically mounted on the side of the throttle body, where it can monitor the position of the throttle plate. To access it, you may need to remove any obstructing components, such as the air intake duct. Always ensure the engine is off and cool before attempting any work on the sensor.
It's on the side of the throttle body, on top of the engine, in the air flow path.
What year is Mercury Outboard with serial # 5863149
# connect fuel line # pump the primer bulb once and once only ! # move the throttle into the start position # ensure the gear is in neutral ( middle position ) # flick the carb switch open # Pull the pull start away to go
By simply storing your outboard in a vertical position, powerhead up, the cooling water will drain out of the engine via the gearcase.
what does a 1991 mercury 150 outboard weigh
hat year is this Mercury outboard 7.5h.p seal #704818
It means a fault in the Throttle Position Sensor circuit.
What year is the 8hp Mercury outboard with serial o6156590 ?
hat year is this mercury outboard 7.5h.p seal #704818