To remove the fender on a 1998 Expedition XLT, start by disconnecting the battery to ensure safety. Then, remove any screws and bolts securing the fender, typically found in the wheel well, along the top edge, and under the hood. Carefully pry the fender away from the body, being cautious of any clips or additional fasteners. Finally, lift the fender off and set it aside, ensuring not to damage any nearby components.
check your answer
The battery is under the front fender of a breeze have to take driver side tire off and inside fender out ,then you will see the battery.
To remove the fender on a 1998 Tahoe LS, start by disconnecting the vehicle's battery to ensure safety. Next, remove any screws or bolts securing the fender to the body, typically found under the hood, along the wheel well, and at the bottom of the fender. You may also need to take off the front wheel for better access. Carefully pull the fender away from the body, taking care not to damage any clips or surrounding components.
You have to take the front wheels off and go through the fender well.
The battery is under the front fender of a breeze have to take driver side tire off and inside fender out ,then you will see the battery.
To remove the driver side fender on a 1998 Ford Windstar, start by disconnecting the battery and removing the front wheel. Then, take off the inner fender liner to access the bolts securing the fender. Next, remove the bolts located along the top edge of the fender and at the front, as well as any clips or screws attached to the door. Finally, gently pull the fender away from the vehicle, being cautious of any wiring or connections.
The fuel pump relay allows the pump to be turned on and off. On a 1997 Ford Expedition, the fuel pump relay is located inside the fender on the driver's side, inside the fuse box.
take the radiator cap off and losen the drain cock on the bottom of the radiator
There is a switch on the light it seft. Off/On/Auto.
no...you have to take out all the water cannister, the computer, the air box horns etc....
Take door panel off. and put window back on track.
LH side or RH side take the plastic shield or inner fender(mud gard) that is below the fender then take the signal lamp off ,after that start taking the nuts that holds the bumper cover and fender close to the tire it could be an 8 or 10 ml socket ,open the door and you'll see 2 more fender bolts take those off also ,under the car where the fender ends it has two more bolts take theme off then on the upper seccion of the fender it has more screws. good luck!