The top of the strut rod should be flattened slightly into a rectangular shape. It should be enough that you can take a crescent wrench and hold the flattened part with it. Use an open end wrench for the nut, putting it on first, then the crescent. Turn them opposite directions to loosen the nut.
That woul mean that the ball landed in one of the remaining 29 slots for 41 and 42 spins. Therefore the answer is 29/37^41 and 29/37^42
Simple answer- Orb weaver from Nicole Caceres, Naga City PI.
your drive belt my be loose or need to be changed. You can try spraying a little wd40 in all the areas that the belt spins around.
It is the whole assembly containing the pull start (if applicable) or the metal or plastic shroud surrounding the flywheel (it spins when you start the engine ).
The distributor pickup assembly is typically located inside the distributor housing, where it senses the position of the rotor. It is mounted near the reluctor wheel, which spins with the engine, allowing the pickup to generate a signal for the ignition system. In some modern engines, this assembly may be integrated into the ignition coil. Proper installation ensures accurate timing for ignition.
2 and 1/2 spins in a 900
The plural of "spin" is "spins."
how does the planet mercury's spins?
'''i am 90% sure that it is spins :) :/'''
The toilet bolt is spinning because the nut securing it is loose. To fix this, tighten the nut using a wrench or pliers until the bolt is secure and no longer spins.
the earth spins on an axis, which is carried over by conservation of angular momentum when the earth was created
A weathervane spins with the direction of the wind due to the force exerted by the wind on its surface area. The design of the weathervane allows it to rotate freely and point in the direction the wind is coming from.