answersLogoWhite

0

I spliced mine in to the power wire on my raido. now if you had in installed go back and have them fix it.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do your muscles attach to your bone?

Muscle and bone are connected by tendons, whereas bone and bone are connected by ligaments.


How do you pull out the instrument cluster on a 1997 Sebring The tach and odometer take about 15 minutes to come on after starting out in the car?

more than likeley this is not a instrument cluster problem, it is probably a cold solder in the engine control module. this is a common thing in this year car(i have a 97 sebring convertible myself). the instrument cluster removal is as follows.... remove the radio trim bezel. remove all screws that attach the dash bezel pull off your cabin fusebox cover. unscrew the screw holding the dash cluster on. lift from the bottom and turn it upwards. there are four clips that hold down the backside but they should just pull out. your dash cluster should be fully exposed. unscrew the mounting screws and turn the back upward. unhook the connectors by pushing the tabs and then pulling outwards. installation.. as always is reverse of removal. when you put the dash back on you have to set it on the wheel and turn the front upwards to clear the steering wheel.


How to disable annoying key reminder chime noise telling you key is in ignition and driver's side door is open in a 1997 Subaru Legacy Outback?

The chime is located in the instrument panel on these model Legacys. Remove the cluster outer ring 4 screws. Then remove the instrument cluster by removing another 4 screws and the 5 wire connectors on the back side. On the back side of the cluster is the circuit board and indicator lamps. On the left side, next to the fuel gauge, is two solder points marked BZ+ and BZ-. These are the connections to the chime. Take a screw driver or exacto knife and scratch out the connection to BZ+. The chime is now deactivated. Before you put the cluster back in, take this time to replace any indicator bulbs not working. Reconnect the wiring and re-attach the instrument panel.


Anyone ever lose there dash lights on a 93 colt.i changed the bulbs and couldn't find a fuse for them?

I have a 1992 Plymouth Colt Vista. My dash lights would work intermittently. I removed the instrument cluster and tightened the small screws that attach the printed circuit assembly to the cluster. I have not had the problem again. Be careful not to overtighten as the screws go into plastic!!! If you need to contact me email me. Brad bkbauto@aol.com


How are muscle and bone connected?

Tendons attach to your bone and muscle keeping them together.


Can a creditor get a judgment and attach your debit card?

They wouldn't attach a debit card, they would attach the bank account. If there is a debit card the account is connected to, I suppose you could say they've attached it.


Can a kitchen faucet sprayer be installed without installing a new faucet?

No, if the current faucet doesn't have a sprayer, there is no place on the faucet to attach the sprayer. It would attach on the underneath side of the faucet in the center.


How do you fix speed odometer cable for 2003 harley davdison sportster?

It depends whats wrong with it, if the cable is simply disconnected all you have to do is make sure its still fit to work and plug it back in to either the front tire or under your cluster (depending where its off) if its connected but still not working then you buy a new cable, remove your old one by unscrewing it from your cluster display, and your front tire. its just a round bolt you twist off (righty tighty lefty loosy) then run your new cable through the same places you pulled it from and attach it to the tire and the cluster.


Can a moen 7400 kitchen faucet be installed without the spray operational?

Get a cap for the connection the spray hose would attach to.


How can a storm door be installed without a frame?

A storm door can be installed without a frame by using a Z-bar or mounting brackets to attach it directly to the exterior wall. This method allows the storm door to be securely installed without the need for a separate frame.


What socket does the microprocessor attach to?

The microprocessor is installed into the CPU socket on the motherboard. A CPU socket can only fit a certain range of microprocessors.


What is the function of aircraft pylon?

pylon is installed under the fuselage to attach drop tank or gundola as per requirement. it can be jettisoned if required.