check for this 1.- Check for motor 2.- Check for plugged lines 3.- Check for frozen lines
has to be replaced, its on the bottom up the washer fluid jug.
Take it to the mechanic
as for as what, the motor, the wipers, the fluid container, what?
You add washer fluid or fix the fluid sensor.
frist check the pump if its good check the sparyers for bild up
how do you fix a front lode washer that is jammed
To fix the windshield washer sprayer on a 2001 Saturn SL2, first, check the fluid level in the washer reservoir and refill if necessary. If the fluid is full, inspect the hoses for blockages or leaks, and clear any obstructions in the spray nozzles using a pin. Additionally, test the washer pump by activating the washer system; if it doesn't work, the pump may need to be replaced. Lastly, ensure all electrical connections are secure and functioning properly.
the front and rear use the same resevoir if the level is low the rear will be inop. I had the hose for the rear window washer come off. I found this out by holding the wash button for a few seconds while parked. I found a puddle of window washer fluid under the vehicle. Very simple fix, pushed the hose back into place. The front and rear use the same reservoir. The rear washer pump motor is located higher on the reservoir than the front washer pump motor. This is why your front washer fluid still works when your rear doesn't. Fill up your reservoir, and you should be good to go. By: FramerBoy
The hoses on the washer fluid pump motor are in the wrong locations. On the bottom of the washer fluid bottle, there is a pump. Swap the rubber hoses and it should work properly.
To fix a windscreen washer system, first check the washer fluid reservoir to ensure it's filled. Next, inspect the hoses for any cracks or blockages and the pump for functionality; listen for a humming sound when activating the washer. If the pump is not working, it may need to be replaced. Lastly, clean the nozzles to ensure a proper spray and check the electrical connections for any faults.
To fix the washer fluid pump on a 2008 Kia Sedona, first check the fuse associated with the washer pump; if it's blown, replace it. Next, inspect the pump for any clogs or leaks, and ensure the fluid reservoir is filled. If the pump isn't functioning despite these checks, you may need to replace it. Disconnect the electrical connector and hoses, then remove the old pump and install a new one, ensuring all connections are secure before testing the system.
To fix a windscreen washer on a Mitsubishi L300 van, first check the washer fluid reservoir to ensure it's filled. If it's full, inspect the washer pump and fuse; the pump may be faulty, or the fuse might be blown. Check the hoses for any blockages or leaks, and clean or replace them as needed. If the pump is not working after testing, it may need to be replaced.