Your heater core, which is under the dash is supplied by coolant from the engine. If it is leaking, or the hoses to it are leaking, it could end up on your carpet. Also, if the drain for the A/C evaporator is clogged, you would have a similar result. This sometimes happens after getting a car undercoated.
"Does the top or bottom heater hose from the firewall go to the water pump on a 1991 Dodge Dakota V6?" The top heater hose from the firewall goes to the water pump and the bottom hose from the firewall goes to the top of the block where the temperature thermostat housing is located.
To effectively connect your garden hose to a water source using a garden hose connector, first ensure the hose and connector are compatible in size. Then, attach one end of the hose to the connector and the other end to the water source, such as a spigot or faucet. Tighten the connections securely to prevent leaks. Turn on the water source to allow water to flow through the hose.
That hose goes to your heater core, follow the hose to passenger side of the firewall.
Look at the firewall in the back of your engine compartment. You will see two water hoses come out . Unscrew and pull off both hoses. Get a garden hose and cut off metal fitting. Twist on garden hose on one of the pipes sticking out of the firewall. Run hose water through it for 5 minutes. Then repeat on other pipe .
Need to replace the water pump.
"Cleaned it out"? The evaporator box or the drain hose? Sometimes algae will grow in the box and plug the drain hose. Quick way to check is to use an air hose and blow up in the hose where it comes through the firewall. If you had the box out, did you kink the hose putting it back in?
Both of the heater hoses come from the firewall. One runs from the firewall to the water pump, this is the outlet hose. The other hose runs from the firewall to the top of the engine, this is the inlet hose.
To repair a hose bib, first turn off the water supply. Remove the old hose bib and replace it with a new one. Use plumber's tape to secure the connections and ensure there are no leaks. Test the new hose bib by turning on the water supply and checking for any leaks.
To install a soaker hose in your garden, first lay out the hose along the plants you want to water. Connect one end of the hose to a water source, such as a spigot or a hose splitter. Turn on the water to allow it to flow through the hose. Adjust the water pressure as needed to ensure even watering. Cover the hose with mulch or bury it slightly to help retain moisture and protect it from damage. Periodically check the hose for leaks or clogs and adjust as necessary.
on the firewall, there are 2
The hose at the bottom of the water pump on a Ford Escape 3.0 is typically the lower radiator hose. This hose is responsible for carrying coolant from the radiator to the water pump, where it is circulated through the engine to maintain optimal operating temperature. It is important to ensure this hose is in good condition and properly connected to prevent coolant leaks and overheating issues in the vehicle.
Common issues with a kitchen faucet hose include leaks, blockages, and low water pressure. Leaks can be fixed by tightening connections or replacing the hose. Blockages can be cleared by removing debris or replacing the hose. Low water pressure may be resolved by cleaning the aerator or replacing the hose if necessary.