0
What else can I help you with?
Changing the camshaft positioning sensor on a 98 GMC JIMMY?
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.
After replacing a fan clutch on a 93 Jimmy what would cause the engine to race when cold and hesitate to shift until it warms up?
There is a sensor on the bottom side of the air intake hose. You may have pulled the connector off. First place to check...
Where is the oil sensor found on a 97 gmc jimmy?
where is the oil sensor on a 97 gmc jimmy
What does a temp sensor sender look like for a 2001 gmc Jimmy?
where it the temp sensor sender located on a 2001 gmc Jimmy
Where is the knock sensor located on 2000 gmc jimmy 4x4 v6 vortech engine?
2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3
What would cause the distributor on a jimmy to click and not start?
Broken rotor button.
Where is the crankshaft sensor for a 1995 gmc jimmy?
The crankshaft sensor is by the crankshaft pullie (the balancer)
What would cause the transmission to make a whining noise when put into gear on a 1999 GMC Jimmy?
The torque converter might be going. but first check your fluid level.
How do you test a crankshaft position sensor on a 1996 jimmy blazer?
To test a crankshaft position sensor on a 1996 Jimmy Blazer, use a CKP sensor to test for voltage output. Compare the results to manufacturer specifications.
What would cause your 1997 GMC jimmy to be stuck in gear?
Is your transmission fluid full?
Where on a 1994 Chevy blazer is the oxygen sensor located bank one sensor one?
where is the oxygen sensor in a 1995 gmc jimmy
How do you install a speed sensor on a 1998 gmc jimmy?
To install a speed sensor on a 1998 GMC Jimmy, first, locate the vehicle's speed sensor, which is typically found on the transmission. Disconnect the negative battery cable for safety, then unplug the electrical connector from the old speed sensor. Remove the mounting bolt and carefully pull out the old sensor. Install the new sensor by reversing the removal steps, ensuring it’s securely in place and reconnect the electrical connector before reattaching the battery cable.
