it is used for making a circler mark
a dot punch is basically a toolusually used in sheet metals,it is a thinner andsmaller version of a centre punch. it is hiton the head with a hammer in order for it to work. this is a typical explaination of a dot punch!
The centre punch is made form mild steel with the point hardened and tempered so that it withstands impact with the material it is marking. It is normally used to mark the centre of a hole to be drilled either by hand or on the drilling machine. The dot punch is a lighter and thinner version of the centre punch and is used basically for the same job. However, it is more accurately as the dot produced is smaller.
Well, basically I'm going to say that a center punch is something you use to mark a dot, in order to drill or mark, or make a dent in a bigger version. So with it you'll recognise where the dot is and that's the place to drill, mark or dent it!!!!Confusing, don't worry try another web site1!!! good luck! ***Signed 12normal girl... ****;)
You can use DOT 4 in place of DOT 3 but don't use DOT 3 in place of DOT 4. DOT 4 has a higher boiling point than DOT 3. DOT 4 is in there for a reason.
What is the use of Ispostback in dot net?"
There is a recipe site online that has recipes for about anything you want. It is called all recipes dot com and they have a few varieties of making fruit punch on there.
The Ak74fu2 Higher rate of fire, a red dot sight and obviously more power
Yes, you can use either DOT 3 or DOT 4 and they can be mixed. You cannot use DOT 5.
Gram
Yes.
No. Use what the car manufacturer calls for.
If the inequality includes 'or equal' then use a solid dot [the value is included]. If it doesn't use 'or equal' then use the open dot.