Super glue is best for this
on the inside of the door, opposite of the mirror there is a plastic cover, remove the cover and the bolts holding the mirror on will be exposed.
To replace the passenger side mirror on a 2008 Pontiac Grand Prix, first, carefully pry off the plastic cover on the interior door panel to access the mirror's mounting screws. Remove the screws securing the mirror to the door and disconnect the electrical connector if your mirror has power features. Install the new mirror by connecting the electrical plug (if applicable), securing it with screws, and replacing the plastic cover. Finally, test the mirror to ensure it functions correctly.
on top of door panel behind the mirror. remove the plastic cover by prying it off. remove the mirror nuts, and then remove mirror. if it has mirror adjustment cables on it. just remove these cables, and put on with new mirror if needed.
To replace the passenger side rearview mirror on a 2006 Malibu, start by carefully prying off the plastic cover that conceals the mounting screws. Next, remove the screws securing the mirror to the door and disconnect any electrical connectors if the mirror has power features. Install the new mirror by reversing the steps: connect the electrical wiring, secure it with screws, and reattach the plastic cover. Ensure everything is tightened and aligned properly before finishing.
To replace the passenger side mirror on a 2008 Ford Escape, first, carefully pry off the plastic cover on the interior door panel to access the mirror's mounting bolts. Remove the bolts using a socket wrench, then disconnect the electrical connector if your mirror is powered. Replace the old mirror with a new one by reversing the steps: connect the electrical plug, secure the mirror with bolts, and snap the plastic cover back into place. Finally, test the mirror to ensure it functions properly before finishing the installation.
Very simple just remove the plastic cover on the inside of the mirro then remove the 3 ten mm nuts and unplug the connector pull out the mirror and your done
To change the temperature sensor on a Peugeot 206, look at the underside of the passenger door mirror. There is a small black plastic bump sticking out of a hole in the mirror body. Remove the cover from the rear of the mirror and attach the new sensor.
There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.
You have to remove door panel to get access to the screws holding the inside plastic cover in place. Remove the plastic cover and then the three nuts holding the mirror.
To tighten the passenger side mirror on a 1999 Silverado, first, locate the adjustment screws or bolts on the mirror assembly. These are typically found on the inside of the door panel or under a plastic cover. Use a screwdriver or socket wrench to tighten the screws or bolts securely. If the mirror is still loose, check for any damaged components that may need replacement.
it is on the windshield behind the mirror..there is a black plastic cover behind the inside mirror, sensor is inside that cover..
I think you have to take off the inner door panel and remove from there...Rick D