For an 8V71 engine, a high-quality, low-silicate antifreeze coolant is recommended, typically a 50/50 mix of ethylene glycol and water. To drain the old coolant, locate the radiator petcock or drain plug at the bottom of the radiator and open it to let the coolant flow out. Additionally, you can remove the engine block drain plugs to ensure all coolant is expelled. Always dispose of old coolant properly, as it is toxic to humans and animals.
I use antifreeze mixed 50 / 50 with distilled water in my 1995 Ford Explorer as the engine coolant as the Owner Guide shows
No , it's best to add coolant when the engine is cold
i have a 94 cadillac sls and i think i blew a headgasket thers oil in my antifreeze resovar and thers antifreeze in my oil whats the best thing to do does steel seal realy work should i drain both of thoes before i use it Yes, but any sealant that's to be used in the coolant system is for emergency situations. It will cause more problems in the long run than it will fix. From the sound of your problem, you need to see a qualified mechanic.
A good quality antifreeze mixed 50/50 with water
The best reason to use water as a coolant is because is because it has a high specific heat capacity. However, you can add a mix of antifreeze with your water.
Remove the lower radiator hose, but make sure your able to contain the coolant to prevent splashing everywhere. ----------- Or, you can remove the drain bolt from the underside of the radiator to drain some of the fluid, and remove the drain bolt from the engine block to get a lot of the rest. To get everything out, you'd either need a flushing machine or you need to flush the system manually. Replace with 50% distilled water and 50% of an antifreeze reccommended for your car.
A sentence for the word antifreeze may be, " What is the best antifreeze to use in drinking water?" Antifreeze is a liquid which is used to lower the freezing point.
distilled water and antifreeze - usually 50/50 mix - up to 60 % antifreeze in cold climates for Ford Vehicles
drain all coolant from system. flush with water until clean water is comming out of engine. fill rad with water and run engine up to temp. this should help remove the antifreeze from the engine. drain water out and run water through system again until clean. add new coolant to system. should be good. use garden hose to flush out system
If the vehicle is cold yes but make sure you mix the antifreeze with water before you add it, 50-50 is the best mix.
It is usually best to add the correct mix of antifreeze and water (usually 50/50). In a situation where there is no antifreeze available, yes, add water, then check the coolant later to see if the mix is adequate, and adjust the mix if necessary.
The drain plug is on the bottom of the radiater but the best way to change it is to have it profesionally flushed