there are several reasons this could happen.distribator cap and wires spark plugs may need to be replaced.there could be oil getting thru and on some of them. if your car doesn't have an electronic ignition the cylinoid could be bad.
Petrol/gasoline cars do use spark plugs.Petrol/gasoline cars do use spark plugs.
only the cars that run on flammable fuel have spark plugs the only exceptions are diesel powered
When changing the spark plugs of a car, it is important to remember to gap the spark plugs. The gap for this cars spark plugs are 0.051 inches.
Disconnect the cars battery, remove the spark plug cables and boot covers, and remove the old spark plugs. Next, put in the new spark plugs, leave the right gap size, connect the boots and cables, and reconnect the cars battery.
Um, ALL cars/trucks/SUV's have spark plugs. What a stupid question.
No, Diesels don not need a spark plug.
either wrong spark plugs or sparkplug gap or you have to plug wires on wrong plugs
You will need the correct replacement spark plugs, a spark plug socket, and a screw driver. The new cars have the spark plugs concealed and you might have to open the cover over the engine to access it, which may require addition tools
A car is required to have spark-plugs in order to run. It's part of the ignition, and basically a needed element for the engine to run.
Misfires are commonly a result of bad spark plugs or the wires connecting to your spark plugs, There is a spark plug for each cylinder of your vehicle which affects your cars ability to start and shift up in gears, depending on which plugs aren't working.
Yes they do... all cars do. They are located below the air filter.
Not all spark plugs are metric Normally European cars will have metric spark plugs, but American cars might have an NPT or a UNC thread form, and old British cars might have BSW, BSF or BSP threads. I guess most plugs are metric though as the famous inventor of spark plugs was a Frenchman named champion. you will have heard of champion spark plugs right. the only way to be sure if the thread is metric or not is to measure it standard metric plugs come in the following sizes m10 x 1mm pitch m12 x 1.25mm pitch m14 x 1.25mm pitch m18 x 1.50m pitch good luck