0
What else can I help you with?
Map sensor 1994 f150 4x4?
Map sensor is on the fire wall on passenger side.It has one electrical connector(three wires) and one vacuum hose on it,right beside your heater a/c housing.
Where is the MAP sensor on avalanche 2003?
It is located at the very back of the engine at the very top and you will see three or four tiny wires going into it
What is diagnostic code 33 on 89 Chevy astro van?
Code 33 is a MAP sensor code. MAP sensor circuit error (signal is high meaning there is low vacuum getting to the sensor). Check the vacuum line going to the MAP sensor. Its usually located on the side of the breather, usually a green plug with three wires in line.
Where is the map sen?
The map sensor is mounted on the left side of the carburetor on a blazer it has a wire harness with 4 wires plugged into the bottom of it
Where is the map sensor located on 2005 Chrysler sebring?
Passenger side near the water inlet (has three wires coming out). It's attached by one phillips head screw located underneath the sensor. Use a stubby screwdriver if you have one.
Why does my 1995 Dodge Intrepid still bring up a map sensor code when i have replaced it and the car still runs poorly?
You need to test the wires at the map.
How many wires on a water temperature sensor for a 2000 ford ranger 4.0?
There are either two or three wires on a water temperature sensor for a 2000 Ford Ranger 4.0.
Where is the map sensor on a 2001 Chrysler Voyager?
Open your hood, standing in front of engine, look on top of the manifold on you right hand side you will see a small device with three wires coming out. That is your part.
Does a 2000 Durango have a MAF sensor or a MAP sensor?
It uses a MAP sensor.It uses a MAP sensor.
Where is the location passlook sensor 2000 Pontiac sunfire?
where is the location posslook sensor three wires , 2000 pontiac sunfire
Where is the Pcv valve located on a 1998 Buick regal?
On the passengers' side of the car you'll have to lift the plastic cover over the engine and look at the MAP sensor located at the passengers' end of the plastic cover (black in color and held in place by plastic clips--making up the entire MAP sensor assembly). There are three wires connected to the MAP sensor. Remove the wire assembly first. The MAP sensor is removed by twisting it counter clockwise (a small pair of channel locks might assist in removing it). There is a large spring just under the MAP sensor that pushes down on the PCV valve. Remove the MAP sensor and spring and then you can access the PCV valve. You might need a pair of plyers to remove the PCV valve. Installation of the MAP sensor assembly is done by replacing the spring, putting the MAP sensor assembly on the spring, assure the assembly is in the counterclockwise position and twisting it clockwise to reinstall.
What is the color and location of the vehicle speed sensor wire on a 2005 Mitsubishi galant?
It is located in the data link connector. There are three black wires. It is the bigger of the three black wires.
