answersLogoWhite

0

You could very well have a blown head gasket. I would advise getting it to your dealer and have it checked asap.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Your 96 dodge Dakota is not idling when warmed up What is wrong?

my 96 dodge Dakota wont idle when engine is warm and i changed idle air controle valve what else could be wrong


How do you set the idling on a 1993 Dodge Dakota It is idling when cold but once it's warm it runs rough and ends up stalling out?

You dont you replace the timing control module


What could be the problem if you are increasingly losing speed in your Dodge Avenger and your engine loses oil pressure while idling?

Dodge Avenger has a problem with this. You need to take off the oil pan because the oil thicken's in the pan. Clean it and put it back on and this should to the trick.


Where is the fuel pressure regulator on a 99 dodge Dakota with a v 6?

The regulator is part of the pump module in the fuel tank on a 1999 Dodge Dakota.


What is the fuel pressure on a 1992 dodge Dakota 3.9?

40psi40psi


Part that maintains pressure to clutch in a 98 dodge Dakota pu?

That would be the pressure plate.


Would a bad o2 sensor cause a 02 dodge Dakota to stall?

Yes, a bad O2 sensor would cause a 2002 Dodge Dakota to stall. It would also cause bad fuel mileage and hard idling within the vehicle.


You have low oil pressure on a 1995 Dodge Dakota what is causing this problem?

Excessive engine wear: bearings Weak oil pump? Bad oil sending unit?


What causes my oil pressure to drop in 1992 Dodge Dakota?

Not enough oil.


What should the cylinder compression pressure be in a 1991 dodge Dakota?

100-125psi


Dodge Dakota misfires under acceleration?

If a Dodge Dakota misfires under acceleration, the problem is either the spark plugs, the coil, or the distributor. It could also be a problem with the fuel pump, fuel filter, or the carburetor.


Where is the AC low-pressure port for the a 98 Dodge Dakota?

the low pressure port is right on top of the comperssor