You can use oil absorbent products sold in auto parts store.
If you have the correct amount of oil in the engine, unhook the negative (black) battery wire for about 15 minutes. Then hook it back up. The light should go off, especially if you hooked up the oil sender wires BEFORE putting the oil in.
The best engine oil to use in a aircraft reciprocating engine is Phillips X-Country. It allows immediate oil lubrication without a warm-up.
NO!!!!! if you do then the engine can start up in flames or even blow up!!!!!
A Conley V8 engine is operated by pumping the oil that is in the holding tank. It is used in factories to pump oil, and dig up gardens. That is how the Conley V8 engine works.
The oil filter is located right next to the oil pan (where you drain the oil) the 7.3 takes 15 quarts of 15W40!! Make sure that you fill the new oil fiter up with oil before you put it on the engine!! If you do not then you will cause the engine to run dry which will damage the internal parts!!
Could be Various places. Jack your car up and look around the oil pan area. If its dry continue looking in various places if everything is dry, oil is being consumed in the engine which is means your piston rings or oil rings are bad. Wouldent suprise me on an old car like that.
It will eventually plug up. You will then either starve the engine of oil, or be pumping unfiltered oil through the engine. Both will lead to engine failure.It will eventually plug up. You will then either starve the engine of oil, or be pumping unfiltered oil through the engine. Both will lead to engine failure.
Yes, gasoline can dry up over time due to evaporation of its volatile components. This can lead to decreased effectiveness and potential engine issues if used in a vehicle.
Just slide up under the engine and look up at the engine. The oil pan is bolted to the bottom of the engine.
There is no Oil lubricating your engine at a cold start up, so a rich mixture is used to try eliminating any scouring on your (internal) engine components.
Running an engine with no oil in it.
Oil is used as a lubricant in an engine. The oil gives a thin coat to metal surfaces, preventing metal to metal contact. This makes the components run smoother and last longer. Without oil, an engine will freeze up in a mater of minutes.