answersLogoWhite

0

Trouble code P0741 means:Torque converter clutch circuit performance or stuck on

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you reset check engine light on 1999 cadillac deville?

The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.


How would you no if your tps going out on a 2000 Cadillac deville?

The check engine light would illuminate.


What causes a Cadillac DeVille to run great and then the dash lights blink on and off and the defrost on the panel come on and the heat can not be turned off?

check ground wire on front of engine behind starter.


Where is the 92 Cadillac deVille oxygen sensor?

check on the back side of the engine by looking underneath the car, you should see it there


Can 22s fit on a 97 Cadillac DeVille?

yes they can just check....... i have a 99 deville


My Cadillac DeVille antenna wont go down when the engine turn off but antenna motor is running?

check your antenna belt/fuse !


Reset check engine light on 1993 cadillac deville?

Have vehicle scanned to determine the problem - usually a problem in the emission control system


1992 deville check engine light?

It is possible to repair the 1992 deville check engine light if it is malfunctioning.


How do you check fuel gauge on Cadillac deville?

Take it to Pep Boys


How do you unlock theft-lock on a 2000 Cadillac Deville radio?

check your answer


98 cadillac deville drive for 10 minutes and the engine overheats?

Check coolant level Perhaps thermostat is not opening to allow coolant to flow


Where is transmission dipstick on 2005 Cadillac deville?

On a 2005 Cadillac DeVille, the transmission dipstick is located near the back of the engine, typically on the driver's side. It is usually marked with a yellow or orange handle for easy identification. To check the transmission fluid level, ensure the vehicle is on a level surface and the engine is running, then pull the dipstick, wipe it clean, reinsert it, and check the fluid level.