answersLogoWhite

0

I was having that problem until the gas station attendant told me to put the nozzle in

all the way and then pull it back about 1 inch , I don't have any problem now

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Are there sensors on ignition which causes the fuel filter to start pumping?

No, the filter can not pump. It is a filter.


Will a fuel pump just shut off when it goes bad?

Sometimes it will and sometimes is will continue to run but is not pumping fuel.


Where is the fuel pump cutoff switch located on a 1998 Toyota tercel?

It does not have a fuel pump cutoff switch.


What causes no fuel to come out of the fuel pump when power is getting to it which causes a 1991 Chevy Camaro not to start?

If the pump is getting power but not pumping, it's probably a faulty pump. It's also possible that the pump pickup screen is blocked.


Is it a pump station or a pumping station?

Typically the term "pumping station" is what is used. When referring to the individual pieces in the pumping station, these would be called pump sets, and each area containing pump sets, within the pumping station, could be called a pump station.


Where is the fuel cutoff switch on a 2002 Chevy blazer?

It does not have a fuel cutoff switch, you have to remove the fuel pump relay to disable the fuel pump.


How can you tell if the water pump is pumping?

If the engine is warmed up, the thermostat has opened and coolant is circulating, the pump is pumping.


Where is the fuel pump cutoff switch in a 1992 mercury sable?

the emegerancy fuel pump cutoff switch would be in the trunk on the left side behind the carpet


Where is the Fuel Pump Cutoff Switch located on a 1994 dodge b250?

Dodge does not use inertia/cutoff switches.


What is the major organ of the circulatory system that causes blood to flow through the body by its pumping action?

The Heat is the pump that circulates blood through the body.


2000 Ford Ranger?

how to reset cutoff to fuel pump


How can I effectively use a manual air pump?

To effectively use a manual air pump, follow these steps: Attach the pump nozzle to the valve of the item you want to inflate. Begin pumping the handle up and down to push air into the item. Monitor the pressure gauge on the pump to avoid over-inflating. Continue pumping until the item reaches the desired level of inflation. Remove the pump nozzle from the valve and secure the item's cap or plug.