The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
What causes a 1998 Pontiac transport to run hot and engine shuts off
OIL FILTER IS A CARTRIDGE STYLE FILTER AND IS LOCATED UNDER THE ENGINE COVER NEXT TO THE DIPSTICK
What causes a 1997 Pontiac sunfire gt with a 2.4 liter engine to stall when stopped at a light
put on a new PCV valve.
Could be low oil level, something wrong with the car's computer system, an oil sending unit...the list goes on..... Depends on which light is on. If it is the Check Engine light then there is a problem that is effecting the emissions system. Have the ECU scanned with an OBD2 scan tool.
The battery in a 2006 Pontiac Pursuit is located in the engine compartment, specifically on the driver's side near the front of the vehicle. It is secured in a plastic battery tray and is easily accessible for maintenance or replacement. To access it, simply open the hood and look for the rectangular battery casing.
One of the possible causes of a Pontiac Bonneville to jerk during acceleration is that the car needs a tune up. The engine misfiring can lead it to jerk as you accelerate.
Scroll to the engine oil life display. When you are on the engine oil life display, hold in the scroll button until the engine oil life goes to 100 percent.
Reduced engine power, on your 2005 Pontiac Montana, can because by several things. The most common cause of reduced power is a lack of fuel.
To reset the engine light on a Pontiac Pursuit, you can use an OBD-II scanner to clear the trouble codes. Alternatively, you can disconnect the negative battery terminal for about 10-15 minutes, then reconnect it. This method will reset the system but may also erase other stored data. Always ensure that any underlying issues are addressed before resetting the light.
probably a bad camshaft sensor.
i think the GTO has the LS2 6.2 That depends on what your idea of a Pontiac engine is. The "New" Pontiac GTO was available with the 6.0 engine. If you are talking about a traditional Pontiac engine, the largest factory offered engine is the 455 from 1970-1976.