0
in the U.S we get drive axles as acheap as 49.00 this is a rebuilt exchange. they are guerenteed 1 year but your car is harder to get parts for a new axle is over400. from dealer i woul call a axle remaufactuer these guy do mobile axles or your local parts store may be able to send yours out for a rebuild ..i would not buy new. and would not pay over 90.00 for you axle shaft. if yours just need the outter boot and is not clicking you can buy a c.v boot replacement kit g
What else can I help you with?
How much would a driveshaft repair cost?
Just got my 2001 dodge Durango front drive shaft on my 5.9 awd replaced $600 after tax and install from the shop.
Daewoo matiz car keeps cutting out?
Researching this for my sister in law. Seems most people have found it to be the optical sensor in the distributor or the distributor itself. Sensor cost almost as much as the distributor so makes sense to change both by replacing the distributor.
Daewoo Matiz wont start after having a new clutch and then distributor still wont start engineer said could be the key?
After the distributor was fitted the engineer took the car round the block and it ws OK. My daughter then drove to the local supermarket and filled up with petrol. The car then started up but wouldn't fire. We had to leave it at the petrol pump and then push it into the car park. It is a 2000 Daewoo Matiz SE. The engineer now thinks it could be the key, we have tried both keys without any luck. Am no wondering how much it will cost to get the keys re-programmed.
When timing belt on 1.6 daewoo nubira breaks in operation does it cause engine damage?
yes it will cause valve damage and will need new gasket kit for it when replaced will cost 0ver 1000 to fix
Is there a fix for a Loud exhaust noise at 2000 rpm on a 2003 buick rendezvous no noise above or below that rpm?
Take it to the dealer crushed metal gasket or something Replaced w rubber and a boot and rocks up in the awd driveshaft. Cost me $300
How much would it cost to have the valves fixed on a Daewoo Lanos?
About $300.00 in Denver, Colorado
How much would it cost to replace a bad universal joint on a 2003 Jeep Liberty?
Well, if it is a front driveshaft, the issue is a CV joint and you'll have to remove the driveshaft and take it in to be rebuilt. Taht will run you $150 or more. If it is a rear driveshaft, it will be cheaper if you remove the driveshaft and take it to a driveline shop where they can press in a new u-joint.....I'd recommend you replace both. A guess? $60 to $80
What is a fast but inexpensive car?
a chevrolet matiz. it cost around £5,000 and top speed of 135mph and 0-60 takes only 5 seconds
H0w much is an electric pump for a 1995 daewoo?
sir i have an original daewoo high pressure fuel pump. I'll sell it to u if u want... normally oit would cost you about 2500-3500 pesos.
How much should wheel bearing cost to be replaced on a 99 Saturn?
Cost me $50 for both sides. Bought the bearings off eBay and replaced them myself.
Can a Nissan Xterra be flat towed?
yes, but only with a Remco driveshaft disconnect installed. Or you could remove the drive shaft if only towed on one occasion. Driveshaft disconnects generally cost $800-1000 installed. They work great and are time proven and trouble free.
How much will it cost to replace drive shaft cable for 2001 Chrysler 300m?
What is a driveshaft cable, your question does not sound lie you using the correct terminology
