0
What else can I help you with?
How do you bleed the clutch on a 99 Saturn SL1?
bleed clutch Saturn vue 2003
Why will your 1985 Pontiac trans am 305 not start with the clutch pressed - started fine earlier - acts as if the clutch is not pressed - same symptoms with and without the clutch pressed.?
There is a switch mounted under the dash above the clutch arm. It has either slipped out of its bracket or is bad. It is there to keep you from starting the car with the clutch engaged. A safety factor.
Why will your 1985 Pontiac trans am 305 not start with the clutch pressed - started fine earlier - acts as if the clutch is not pressed - same symptoms with and without the clutch pressed?
there is a safety switch on the clutch, it should be on the inside of the car that the pedal has to activate so the car will start, apparently that switch is bad.
Can you stop a semi truck in high range with the clutch pressed?
Not with the clutch by itself.
What is a clutch safety switch?
It prevents engine cranking unless the clutch pedal is pressed.
Does the 1997 Saturn SL1 have a sensor on the clutch?
Not on the clutch itself but on the clutch pedal there is one for starting.
If you have 110000 miles on your 2003 Saturn vue clutch does it need replacement?
i have 230xxx on my 2002 Saturn Vue and i never replaced the clutch
Where is the clutch bleeder valve on a 1993 Saturn sl2?
It SHOULD be on the clutch slave cylinder. Follow the hydraulic line from the clutch master cylinder down to the slave cylinder. Depending on the vehicle, it could be behind the dust cover of the bell housing.
How do you adjust clutch pedal on 2000 Saturn?
The clutch pedal cannot be adjusted
Which pedal in a car is pressed when changing gears?
the clutch pedal
What is wrong when a clutch pedal is half pressed and at the same time the accelerator is pressed?
if I understand the question you asked correctly, I would say you are in need of a clutch but it might need adjustment but not likely.
Can an ac compressor clutch for a 2003 s10 4.3 be shimmed or does the clutch need to be replaced?
The compressor clutch does not need to be shimmed. The outside disc is pressed on until the proper air gap is achieved. If it is pressed on to far it has to be pulled off and reinstalled.
