0
What could be wrong if the battery light stays on and the battery still runs down on a 1994 Mitsubishi Mighty Max after installing a new battery and alternator?
the only thing that is left is the regulator which should have being replaced first in the first place Rocky_B - See my entry here for more things you might want to check: http://wiki.answers.com/Q/What_could_be_wrong_if_the_battery_light_stays_on_and_the_battery_still_runs_down_on_a_1996_windstar_after_installing_a_new_battery_and_alternator
What else can I help you with?
When replacing the ECU on a 1992 Mitsubishi Mighty Max does the computer memory have to be reset?
no just unhook the battery posts so that you dont fry the computer when you are installing it. Then reconect the battery posts when installed and try to start it without patting the gas padle it should fire right.
Why is the battery not charging on a 94 Mitsubishi Mighty Max Pickup?
is your "NO CHARGE" warning light coming on? if not this could simply be the problem, on some vehicles the charging circuit incorperates the "NO CHARGE" bulb and if its blown the vehicle wont charge. COuld be an alternator problem ( worn bushes etc) or faulty earth lead from alternator.
How do you install an alternator on a 93 Mitsubishi mighty max truck?
If you want to keep your radio stations they sell a plug for your cigarette lighter that holds a 9 volt battery, this will keep your stations and also your memory on your computer so it wont have to relearn its idle strategie after you reconnect your battery. Plug this in First, THEN disconnect your battery.Then loosen the top bolt on the alternator, remove all wires on the alternator, remove belt, remove completely the bottom bolt. Hold on to the alternator and remove the top bolt completely then remove alternator. Install in reverse procedure.
Does your 1992 Mitsubishi mighty max have a voltage regulator and where is it located at?
I have no clue where voltage regulator is at on 1994 Mitsubishi mighty max can you help?
How do you change the timing belt on a 2.4 Mitsubishi mighty max engine?
To change the timing belt on a 2.4 Mitsubishi Mighty Max engine, first, disconnect the battery and remove any components obstructing access to the timing cover, such as the alternator and power steering pump. Align the timing marks on the crankshaft and camshaft to ensure proper positioning, then remove the timing belt tensioner and the old belt. Install the new timing belt, ensuring it is properly tensioned, and reassemble any removed components before reconnecting the battery. Always refer to a service manual for specific torque specifications and detailed steps.
What is 1985 Mitsubishi mighty max worth?
500
What diesel engine fits in a 1987 Mitsubishi mighty max?
Mitsubishi 2.3L 4D55 Turbo
How do you lift a Mitsubishi mighty max for free?
with a floor jack.
why does What if your 1991 Mitsubishi mighty max die after you start it up?
If your 1991 Mitsubishi Mighty Max dies after you start it up it could be one of several issues. There can be issue with the batter, fuel relay, or distributor.
Why does your 1991 Mitsubishi Mighty Max 2.4 truck start up then die right away?
my 87 just had this problem...it was the mass air flow sensor. if its not that try the computer my 86 had the same problem, it was the Mass Air Flow Sensor
How do you change timing belt on 1988 Mitsubishi mighty max with 2.0 engine?
Timing belt replacement on 88 mighty max
How do you replace the drive belt on a 1991 Mitsubishi mighty max truck?
Need a diagram to set the timing Mitsubishi 1991 pu
