0
What else can I help you with?
Why is a dual line braking circuit better single line system?
If fluid is lost due to component failure, you will get total brake failure (loss of all braking except parking/emergency brake) on a single circuit system. A dual circuit system will only fail in one circuit, leaving the remaining circuit working. It is therefore safer.
What does a explanation point light mean on your 97 Volvo 960?
Brake circuit failure. Normally this means the brake fluid level is too low.
I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?
If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.
Where is the brake light failure sensor located on a 1998 accord?
The brake light failure sensor is located at the back of the left rear lamp assembly behind the trunk liner. It is a square circuit board about 2" x 2" connected by a wire pigtail to the main left rear brake and running lights.
What does C1287 mean on 2002 Lincoln LS?
Code C1287: Brake Lamp Inhibit relay circuit failure. Problem with the warning lamp circuit, or the antilock control unit/module it monitors.
Brake lights do not work all the time replaced brake light switch?
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
Why aren't my 1987 Toyota Camry brake lights working?
im having the same problem on a 89 Camry already replaced the yellow box lamp failure sensor found at junk yard for 50bucks dealer wanted 250 but the lights still are not working
What is the cause of a whistle sound on left wheel It's intermittent and as soon as I hit the brake it disappear. It normally happens when I driving on speed of 31 mph. Is it perhaps wheel bearing?
It is a "chirper spring" that is warning you that you have very little brake pad left. ------------------------------------------------------------------------------------------------------- Thanks for the answer, but I have already replaced the brake pads and brake disc. Before, I replaced that stuff, the sound was not there.
Why can a small leak lead to brake failure?
Yes . Over time brake fluid can leak out and cause a failure.
What would be causing a scrubbing noise in rear brakes when you already replaced brake pads in a 96 grand jeep Cherokee Laredo?
The brake pads might not be adjusted properly. The brake pads can be too tight and have contact with the rotors.
How do you wire a XB Falcon brake failure switch?
To wire a brake failure switch on an XB Falcon, first locate the switch, typically mounted on the brake line or near the master cylinder. Connect the switch's terminals to the brake warning light circuit, ensuring that one terminal connects to the power source (often from the ignition) and the other to the brake warning light. When the brake system experiences a failure and pressure drops, the switch will close, illuminating the warning light on the dashboard. Always consult the vehicle's wiring diagram for specific details and ensure all connections are secure.
Do brake rotors need to be replaced if there is no noise shimmy or other brake issues?
When Brake Rotors Are To Thin To Turn On A Brake Lathe To Have The Minumn Thickness. They Need To Be Replaced.
