answersLogoWhite

0

The coolant enters the engine by way of the lower radiator hose and exits the engine by way of the upper radiator hose.

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

How many quarts of coolant needed for 2000 Chevy silverado 5.3l engine?

A 2000 Chevrolet Silverado with a 5.3 liter engine takes 13.4 quarts of coolant. It is suggest that the coolant be mixed 50/50 with water.


What does the code PO117 Engine coolant temperature circulating low input mean for a 2000 Chevy Astro Van?

Monitor your engine temperature and your coolant levels. Chances are you need to add more coolant to the car.


Does a coolant hose go through the fuel injection system of a 2000 Chevy Blazer 4.3 liter engine?

No it does not.


What would be leaking under your 2000 chevy s10 that is pink in color?

Could be "Dex-Cool" engine coolant.


Where is the engine block coolant drain plug located on 2000 Chevy s10 four cylinder?

Rear of the engine block, near the oil pan.


2000 Chevy Malibu coolant?

it takes dex-cool coolant,


Location of coolant level sensor in a 2000 Chevy surban 5.7 ltr. engine?

It is in the bottom of the over flow tank.


What are tesigns of cracked intake gasket on a 3.8 engne 2000 Chevy Impala?

Engine coolant leaking internally and/or externally.


Where is coolant temp sensor on 2000 Chevy s10 blazer with 4.3 vortec engine?

Drivers side of engine, between the #3 and #5 spark plug.


Where is the cooling sending unit on a 2000 Chevy s10?

Assuming you mean the engine coolant temperature sending unit, we need to know what engine it has, it makes a difference.


How do you bleed air out of the coolant system in a 2000 Chevy tracker?

To bleed air out of the coolant system in a 2000 Chevy Tracker, first ensure the engine is cool and remove the radiator cap. Start the engine and let it run until it reaches normal operating temperature, allowing the thermostat to open. As the engine runs, keep an eye on the coolant level in the radiator; add coolant if necessary. Finally, rev the engine slightly and check for any remaining air bubbles; repeat this process until the coolant level stabilizes and no more bubbles are visible.


Where is the location of engine block coolant drain on 2000 1.6 L Chevy Tracker?

I am looking for the same thing post if you find answer please.