answersLogoWhite

0

"AL" on a fuse typically indicates that the fuse is made of aluminum or that it is designed for aluminum wiring. It's important to use the correct type of fuse for aluminum wiring due to its different thermal and conductivity properties compared to copper. Using the wrong fuse can lead to overheating or electrical failures. Always check the specifications to ensure compatibility with your electrical system.

User Avatar

AnswerBot

1y ago

What else can I help you with?

Trending Questions
What would cause a ticking noise coming from your right front tire? What could cause a antifreeze leak when the car is turned off on a 1999 Cadillac Catera? What type of headlight bulb does a 2004 infinity g35 coupe take? Can you drive a car with a broken leg? What grade oil for lower crankcase for a 9.9 Johnson ob motor? How do you change the rear differential fluid on a 2005 Honda crv? 91 jeep wrangle has no spark. Replaced crank sensor dis cap rotor button and coil have pressure on fuel rail.local parts store says replace ingition control module said it should be on firewall? Where is the fuel filter located on a 1999 Saturn twin cam? Why is my alternator wire to battery melted in half at the alternator? Is a 302 marine engine same as a car engine? How do you bleed a 1998 Dodge Ram 1500 clutch system? Why Battery will not stay charged alternator and battery are good? What kind of transmission fluid for a 1993 Toyota Camry? What is the spark plug gap for a BMW 528e 6 engine? Can a 2000 Chevrolet S-10 Blazer steering wheel and airbag be replaced with an aftermarket steering wheel and no airbag? Why is it that when trying to start your Bonneville the security light comes on not allowing the car to start and then you have to wait 3 minutes to try again? What is the recommended tire pressure for 265 75 R16? Why did Judge ford conclude that Mrs.Wexler was not related to Wr.Wexler? How do you replace a 99 Ford Ranger rear bumper? How do you drain water in fuel ford f-350 2006 diesel?