answersLogoWhite

0

What else can I help you with?

Related Questions

Car makes rattling noise while speedng up?

sounds like the cv joints need replaced


How do you replace cv joints 1999 Malibu?

The CV joints in 1999 Malibu can be replaced by removing the front tires and moving the brake lines out of the way. Next, you will need to remove the nuts for the CV joints by using force to remove it from its housing.


Vw polo 1.4 tdi timing?

how often do cv joints need to be replaced in a polo tdi


How do you replace the CV joints on a 1995 Ford Taurus?

The CV joints on a 1995 Ford Taurus can be replaced by removing the front tires, and the nuts on the lower ball joint. Next, the lower ball joint will need to be removed and the CV joint can be removed.


If ball joints were replaced wouldn't cv joints also be replaced?

Not unless that was part of the original work order. These are two distinctly separate parts - especially considering the CV (constant velocity) joints are part of the axle assembly.


What is the clicking noise in driver side front tire every time it makes a revolution?

CV joints need to be replaced


Do CV joints wear out faster on Cadillacs?

How long a CV joint lasts is directly proportionate with how you drive your car. If you corner hard and accelerate hard, your CV joints won't last as long as the CV joints in a car that has been driven in a more conservative manor.


How do you replace opel cv joints?

That depends which model it is. On older models CV-joints were moulded into the driveshaft. To be replaced they had to be removed using a press and then warmed to be able to replace them. On these models it is often better to replace the whole driveshaft. On newer models CV-joints are attached with clips and can be replaced more easily.


How many CV joints are on a Honda?

What Honda are you talking about? Honda makes many different car's and suv's all with different # of CV joints. For a front wheel car it has 4. Thanks.


Do my cv boots need to replaced my car shakes?

My 97 RL was shaking badly too despite new tires & l just had both cv axles replaced and the shaking ended.


What would be the cause of a car grinding noise when straight or turned to the right when turned to the left the noise goes away it only makes a noise when moving?

Your CV joints could be going bad. Check to see if your CV boots are cut or opened to the elements. If so, your joints may need to be replaced. Before your spend money have a mechanic verify your complaint.


How do you replace CV joints on 1996 Ford Aerostar?

The CV joints on a 1996 Ford Aerostar can be replaced by removing the nuts and bolts on the tires. Next, cotter pins, lower ball joints, and the outer joint will need to be removed. Then a pry bar can be placed between the transmission and the inner joint, which will make it easy to pull out.