what does emissions garage mean on a vw touran
The warning light could be for anything engine, alternator,abs, ect it would be best to go to your local garage for an OBD check this is where they plug your car to a computer to find the fault.
To install a garage sub panel, you need to first determine the appropriate size and location for the panel. Then, you will need to run a conduit from the main panel to the garage, install the sub panel, connect the wires, and properly ground the panel. Finally, you will need to test the panel to ensure it is functioning correctly and safely.
Yes you do. The detached garage will either be fed with a single circuit or a sub panel. The wire feeding the garage will need to be protected and that is the purpose of the breaker (disconnect). The breaker size will be determined by the size of the wire that is used on this circuit.
The 2005 Volkswagon Touareg OBD 2 port is on under driver side dash next to kick panel
To install a sub panel for a garage, you need to first determine the appropriate size and capacity for the panel based on the electrical needs of the garage. Next, you will need to obtain the necessary permits and follow local building codes. Then, you will need to run a new electrical line from the main panel to the garage, install the sub panel, connect the wires, and properly ground the panel. Finally, you will need to have the installation inspected to ensure it meets safety standards.
Repair Garage Door, Tension Springs, Garage Door Maintenance, Garage Repairs, Garage Door Panel Repair, Garage Door Roller Repair, Garage Door Cable Repair, Garage Door Installation, Garage Door Replacement
Repair Garage Door, Tension Springs, Garage Door Maintenance, Garage Repairs, Garage Door Panel Repair, Garage Door Roller Repair, Garage Door Cable Repair, Garage Door Installation, Garage Door Replacement
The best place to have the alarm panel is near the entry door for easy access when entering the garage. If you try and conceal the panel it could cause complications at a later date.
Garage Door Repair, Roll-Up Garage Door, Garage Door Tracks, Garage Door Hinges, Garage door Installation, Garage door Spring, Garage door Opener, Fully-Stocked Trucks, Garage Door Panel Repair
The recommended amperage for a sub panel in a detached garage with a 60 amp capacity is typically 60 amps.
Depends on the size of the sub-panel in that garage. If you are installing a 60 amp sub-panel 400 feet away from the main service panel then use AWG # 4.
Garage Door Repairs, Garage Door Spring Repair, Automatic Garage Door Repair, Repair Garage Door Opener, How To Replace A Garage Door Panel, Garage Door Torsion Spring Repair, Garage Door Torsion Spring Replacement, Replacing Garage Door Cable, Emergency Garage Door Service, How To Replace Garage Door Rollers