answersLogoWhite

0

It means your charging system has a problem. More than likely the alternator is failing.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What does diagnostic code P 0522 on dash mean?

Oil pressure circuit low voltage


What does an amber tap light mean on a car dash?

water level is too low


What can cause low voltage in a car?

Alternator going out.


What does range mean on the dash board it says lo it's a 1992 Cadillac?

"LO" is just short for "low". It refers to low pressure (oil), low temperature (coolant), or low voltage (battery/charging system). Unlike low voltage and low oil pressure, Low coolant temp isnt a bad thing that's why that "Lo" isnt red but the other two are.


Why does a low voltage circuit create more amperage than a high voltage circuit?

That depends on what you mean. If you mean why does a circuit which has a high voltage side and a low voltage side have a greater average current on the low voltage side, it is probably because of power conservation: P = IV. If this is not what you mean, you will have to be more specific!


What does it mean when the parking brake light comes on the car dash?

Either your parking brake is on or the BRAKE FLUID level is LOW in the brake master cylinder


What is lo on the dash of a 1998 Subaru Forester?

That means that the car is in low gear.


What does the exclamation in a circle mean in the dash?

low tire warning


Car has very low voltage?

Put a new alternator on it or tear the old alternator apart and replace the voltage regulator in it.


Warning lights that appear on the dash of a 1993 Toyota Camry?

There are several warning lights on the dash board of a 1993 Toyota Camry. There is a hot water warning, a low voltage warning, a low fuel warning, and several others.


What does low fuel voltage mean in 1999 Jeep Grand Cherokee?

it means that its a low fuel


Can glue gun be attached to car battery?

If you mean if a regular household hot glue gun can be run off a car battery, then - no. the voltage is too low for it to heat up enough to activate the glue properly.