0
What else can I help you with?
Is there a reset button for a 1989 ford bronco 2 fuel pump relay?
Not for the relay but there is an inertia switch re set on the right side, under passengers side kick panel. It is a red button, the inertia switch is there to shut off fuel flow in the event of a crash to prevent fire, or at least recuce risk and intensity of fire
Where is the emergency fuel shut off switch on an 1986 bronco?
there should be a inertia switch under the carpet on pass. side of truck right by the dash board. has 2 wires one is pink w/ black stripe ( on mine) i bypass this and just splice the wires together
How do you change the ignition switch in a 1987 Ford Bronco 2?
Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê
Where is interia switch 86 bronco 2?
The inertia switch in a 1986 Ford Bronco II is typically located behind the right side of the dashboard, near the passenger footwell. It may also be found in the engine compartment, near the driver's side fender. This switch is designed to cut off fuel to the engine in the event of an accident, helping to prevent fires. Always consult the vehicle's service manual for the exact location and instructions.
Where is the fuel cut off switch located on a 1987 ford bronco 2?
The Fuel Cut Off switch is actually called the Fuel Inertia Switch and it is located on the passenger side floorboard near the hump underneath the carpet. Just pull the carpet back from the firewall and you will see it. To reset it pull the white tab up (or push down to shut off. But I don't recommend this because tampering with it too much will cause it to fail, and your truck will no longer start until its replaced.)
Will a 1988 FWD bronco 2 transmission fit a 1987 2wd ranger?
no the transmissions are different and it wont work.
Help please my 1987 bronco 2 cranked over and got stuck and just kept trying to crank even when key was out it died after 5 min replaced starter and solenoid yesterday still will not start?
I would suspect the ignition switch has failed. This is the ignition switch not the tumbler assembly that you insert the key in.
Why does my 1987 ford bronco 2 idle for 5 to 10 seconds then die?
Check the TFI module. It is located on the distributor.
You have an 88 bronco 2 head lights were working fine the night before next night no headlights except on bright and no turn signal either but the hazard lights work Any suggestions fuses looked fine?
Your switch in the steering column that controls the high beems and the turn signals is bad. I have had to change it on both 1987 bronco ii that I have owned. Not to difficult to do.
Where is the fuel pump shut off switch for a 2003 stratus coupe 2 door?
Dodge does not use inertia/shut off switches.Dodge does not use inertia/shut off switches.
Why does your 1987 Bronco 2 jump and then die when you put it in drive or reverse?
I would check the idle air solenoid on the intake manifold
What is causing a rattling noise from the transmission or clutch of a 1987 ford bronco 2?
probably the through out baring or ur trany is goin out
