answersLogoWhite

0

Ok, I am assuming you accidentally poured ATF in the master cylinder. Remove this immediately. Have the entire brake system flushed and replenished with the proper brake fluid. Brakes will not function properly with ATF. This is a dangerous situation, not to be ignored. ATF has different base chemical compositions, boiling point, and properties, and should not be mixed or substituted for in a brake system. Mixing or substituting these types of fluids will destroy rubber and plastic components within the system. It can also alter the performance characteristics of the brake system.

User Avatar

Wiki User

20y ago

What else can I help you with?

Related Questions

What would cause air in the brake lines of a 1998 ford escort?

When replacing brake lines, wheel cylinders or calipers air will get into the lines because they were taken apart. Usually air gets into the lines before you work on it because the master cylinder got too low on brake fluid letting air into the lines. Also a bad seal on a caliper piston and a brake wheel cylinder will allow air into the lines.


Where do you put the brake fluid in the 1992 Ford Escort?

The brake fluid in a 1992 Ford Escort gets put in the brake fluid reservoir. This is normally located on the master cylinder.


Where is the clutch reservoir on a 98 ford escort?

The clutch master cylinder gets it's fluid from the master brake cylinder reservoir. The clutch is below the brake and gets it's fluid by gravity. If you need fluid just add to the brake reservoir.


Where do you put clutch oil for 1991 Ford Escort?

The clutch does not use oil, it uses DOT3 brake fluid. The clutch cylinder gets its brake fluid from the brake cylinder and is directly below it. Add fluid to the master brake cyliinder reservoir.


Why bleed brakes?

Air gets trapped inside the brake lines. They become mushy because the fluid that is needed to push the brake pistons is low, and eventually they will fail. Bleeding your brakes makes sure that there is fluid in the lines instead of air. It's not that hard to do yourself, if that is what the problem is. Don't pay someone if you can get someone to help you do it yourself. It is a two person job, pretty much.


What happens when the IH 460 D fluid on a tractor gets low?

The IH 460 D fluid is the hydraulic fluid. The tractor can overheat when the fluid gets low.


Is it okay to soak brake fluid out of the car as opposed to leak?

When soaking the brake fluid out of a reservoir, make sure to use as lint free of a cloth as is possible. If lint or debris gets into the brake system then brake problems can occur.


Where is 1995 escort clutch fluid located?

The clutch gets its fluid from the master brake cylinder reservoir. The master clutch cylinder sits just below the master brake cylinder reservoir and is fed fluid by gravity.


What happens when a fluid starts to cool down after being heated?

it gets coldit gets cold


How water in brake fluid causes a loss of braking force?

The water will boil when the fluid gets hot. Steam in the fluid will causes a loss of hydraulic pressure.


What brake fluid gets used in a 2003 mercury mountaineer?

According to the 2003 Mercury Mountaineer Owner Guide : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A )


Why does the warning brake light go on?

Four Possible reasons... Low brake fluid - check the brake fluid level in the master cylinder Emergency brake is on - check emergency brake Low brake fluid pressure - such as a broken brake line or a bad wheel cylinder. Check the master cylinder to see if it is empty. If you add fluid and pump the pedal you will probably see brake fluid on the ground or on the inside of the tires. Possibly a bad master cylinder. - The fluid will stay full but you will have no or little brake pressure. Could be air in the system as well. BE CAREFUL If you happen to add power steering fluid or transmission fluid to the master cylinder instead of brake fluid you will destroy the system. Make sure you use ONLY brake fluid and clean the master cylinder cap off with a clean rag first so no dirt gets into the braking system.