0
What else can I help you with?
Nothing happens when you turn the key on your 91 cutlass supreme?
dead battery or try taking the battery terminals off and cleaning the terminals and battery cables with a wire brush and rehook.
Why does my car battery spark when I connect it?
When you connect your car battery, sparking can occur due to a sudden flow of electricity between the battery terminals and the cables. This can happen if the connections are not made properly or if there is a buildup of corrosion on the terminals. It is important to ensure proper connection and clean terminals to prevent sparking and potential damage to the battery or vehicle.
What will happen if terminals of the battery are reversed?
If terminals of the battery are reversed, it will short the device that is using the battery. On a car reversing the cables can blow fuses, melt wires, and fry computers.
Clicking noise F150 2000?
The starter or battery cables/terminals are corrode.
How do you replace battery cables 1999 mercury mountaineer?
To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.
How is the battery hooked up on a 1979 camaro?
Clarify please, 2 cables go to 2 terminals on battery.
How do you charge a motorcycle battery with a car battery?
You must get a couple of so-called jumper cables. The cables have strong clamps on them and are designed to be clamped to the battery terminals. Attach the black cable to the negative terminals of the motorcycle and car battery first. Then attach the red or positive cable to the positive terminals of the motorcycle and the car battery. In case your motorcycle battery is empty, you can now start the bike from the car battery. Disconnect the cables in reverse order, beginning with the red cable. The motorcycle battery will not be charged much by the car battery but the bike can be jump started by using this method.
How do you jump start a 1988 Honda Shadow?
Connect the bad battery to a good battery with jumper cables. Connect the positive terminals first, then the negative terminals. Now try to start the engine. When finished, disconnect the jumper cables in reverse order.
How to replace 2002 Pontiac Montana Battery?
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
After replacing battery terminals car wont start?
Replacing battery terminals??? How did you accomplish that. Do you mean you replaced the battery or are you referring to the battery cables? If you replaced the cables are you sure you have them connected correcty and tight. Especially the ground connection. Take a reading with an ohm meter from the neg battery post to the engine or chassis. If the circuit is open, you have a bad connection.
How are the steps listed in how to jump-start a car battery organized?
The steps for jump-starting a car battery are typically organized in a clear, sequential order to ensure safety and effectiveness. They usually begin with gathering the necessary tools, such as jumper cables and a working vehicle. Next, the process involves connecting the cables in a specific sequence—starting with the positive terminals, followed by the negative terminals. Finally, the steps conclude with starting the dead vehicle and removing the cables in reverse order to avoid any electrical issues.
What types of battery cables should one use when trying to jump start a dead battery?
Jumper Cables. If your battery has died, you may be able to use jumper cables to jump start it from some good Samaritan_Ü_s vehicle. If you can safely use jumper cables on your vehicle, make sure that the battery on the good Samaritan_Ü_s vehicle has at least as much voltage as your own.
