0
What else can I help you with?
Your serpantine belt screeches after you put a new belt tentioner and belt dressing on you cant figure out why?
Never use belt dressing on a serpentine belt. Clean the dressing off and recheck the pulleys.
How do you remove belt dressing?
There are a few things to try but the best solution is to never use belt dressing on anything but a v-belt and don't use it then unless it's an emergency. You can try spraying WD-40 on the belt in small increments instead but usually a noisy belt is a signal for a new belt or some adjustment to pulleys or tension. To remove belt dressing you can try some mild soap and warm water which might work if it hasn't adhered to the pulleys too much. If it has then you probably need to pull the belt and clean the pulleys with brake fluid, carb cleaner or something similar. Possibly steel wool will be required to get all the gunk off. Then put on a new belt, it's almost impossible to remove dressing from your belt and even if you could you'd likely be back to your original problem, a worn or noisy belt. The best solution is to NEVER use belt dressing. Back in the 70s you could use it on an alternator belt but cars and belts have changed a lot since then. I would never suggest using belt dressing on any car made in the last 30 years.
How do you remove dress?
There are a few things to try but the best solution is to never use belt dressing on anything but a v-belt and don't use it then unless it's an emergency. You can try spraying WD-40 on the belt in small increments instead but usually a noisy belt is a signal for a new belt or some adjustment to pulleys or tension. To remove belt dressing you can try some mild soap and warm water which might work if it hasn't adhered to the pulleys too much. If it has then you probably need to pull the belt and clean the pulleys with brake fluid, carb cleaner or something similar. Possibly steel wool will be required to get all the gunk off. Then put on a new belt, it's almost impossible to remove dressing from your belt and even if you could you'd likely be back to your original problem, a worn or noisy belt. The best solution is to NEVER use belt dressing. Back in the 70s you could use it on an alternator belt but cars and belts have changed a lot since then. I would never suggest using belt dressing on any car made in the last 30 years.
How much pressure does it take to put on a fan belt?
On what?
What happens if the timing belt is not properly intalled?
In this case your car will give black smoke and it wont have much power to it and you have to get the timing belt taken off and set it up to its right place then put the belt back on it. Rememer your engine will be bit loud voice wise and if the belt was not installed properly.
How much does it cost to fix serpentine belt for Cadillac Seville sts99?
At a dealer... 60 for the belt, about 100 to put it on
You just bought a 2002 Chevy Malibu and it has a squeaky fan belt how can you go about fixing it?
first try buying a small can of fan belt dressing and carefully put it on the SIDES of the belt (where it contacts the pulley). Also the belt may be streched - so you can try to tighten the belt by adjusting the takeup adjustor. Or finally replace the belt - if none of these work. Your car does not have a fan belt. Belt dressing is bad mmmmkay. Messy and will cause more problems (redneck temporary fix). Make sure your belt is tight or have someone check it for you. If it is a serpentine belt (tension is spring loaded) check the tensioner and check for bad pulley bearing. But in 2002, most fans are electric. which means no belt to squeal.
What is it called to put on as clothes?
Dressing.
How much does it cost to put a timing belt on a 1990 Nissan?
$98.76 cheap!
Can you fight your seat belt ticket when you were wearing your seat belt but put it under arm?
how much the fine for first time under arm seat belt fine
96' Ford Windstar has a LOUD squeaking sound you know its one of the pulleys so you put belt dressing on it then it stops for a minute and comes back just as badand the belt is tight What do you do?
THE BELT ITSELF MAY NEED REPLACEMENT.ALSO YOU SHOULD NOT PUT ANYTHING ON YOUR BELTS THEY SHOULD JUST BE INSTALLED AS THEY COME.ANY ADDITIVES SHORTENS THE BELTS LIFE.CHECK THE BELT IT MAY BE CRACKED OR GLAZED.( IF IS THE PULLEY IT SELF NOT THE BELT YOU COULD TRY SOME HIGH TEMP BEARING GREASE BE CAREFUL NOT TO GET ANY ON THE BELTS.)
How much weight can you lose by eat 3 salads per day?
it depends on how much u exercise and if u put on a bunch of dressing and ur metabolism
