answersLogoWhite

0

Should have no screws since turns with wheel. If you mean studs-they don't have heads.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you get to the brake light bulb on a 2002 Chrysler Sebring?

peel back the trunk liner.....should be two or three screws. unscrew and pull the entire light assembly out its a pain in the but!


How do you change a 2002 Chevy Trailblazer brake light?

Changing the rear brake lights and turning lights are very simple. All you need is a Philip screw driver and about 10 minutes. First, unscrew the two screws that hold the entire light assembly. Second, Uncrew the other screws to free the light strip. Pull out the bulb you are replacing and insert your new bulb. Place the light strip back into the light assembly and tighten the screws. Last, Place the whole light assembly back and tighten the two screws.


How do you change the rear brake pads on a 2002 Volkswagen jetta?

How do you get the brake piston to retreat back in caliper ?


How do I replace the third brake lens that is in the back window?

well if you look on the brake lenses there should be screws on them take them off and your lens comes off


How do you change brake light in 2001 olds auorora?

Disconnect the four plastic screws holding the plastic plate in the back of the trunk. This exposes the tail and brake lights.


How do you take apart 2002 grand prix dashboard?

A 2002 Grand Prix dashboard is held on by several mounting screws and clips. Find all the screws and remove them. Take the dash and pull it back.


How did Jenna Fischer brake her back?

Jenna Fischer broke her back in four places while attempting to go down stairs in high heels.


What is wrong when all your brake lights are out on your 2002 Hyundai Elantra including your brake light in the back window if it's not the fuse?

Chjeck the brake light switch located somewhere on the brake pedal lever.


How do you change the rear disks brake pads on a 1994 mustang I cant get the piston to compress do I have to remvoe anything to do with the emergency brake?

it dosent just push back in anymore , u have to turn it , it screws in.


What do I do if the brake light came on in my 2002 Ford Ranger brake is not on but the brakes seem suddenly super squishy?

You probably need to change your back brakes.


How to change the brake light in a 1990 Nissan pickup?

Open the tailgate. About 5" back from where the tailgate closes, there are two 10mm screws on the edge.


What is the problem on a 1998 Monte Carlo Z34 when only the right side rear brake need to be replacedonly after 4000 miles?

if you have disc brake on the back its your caliper, it might be not releasing and if you have drums on the back a part might be broke or come off.