answersLogoWhite

0

What else can I help you with?

Related Questions

What is the size of 351 windsor block freeze plug above starter. I know that is a its a npt pipethread?

If it is a freeze plug it would not have threads. Freeze Plugs are designed to pop out of the block should the water in the block freeze. This could not happen if the plug was threaded. Hope This Helped.


How do you replace a freeze plug in a 1995 Ford Aerostar?

take a large screw driver and a hammer tap the old freeze plug in the block,replace it with a rubber freeze plug.tighten the rubber freeze plug with a wrench..the metal freeze plug that you pushed inside the block will not hurt anything..hope this helps!!!!


Where are freeze plugs located?

A freeze plug is located in the side of an engine block that is supposed to protect the block against freeze damage.


How do you retrieve a freeze plug if it falls into the engine block?

You might be able to fish it out using a section of coat hanger wire or one of those magnets with a flexible handle. Failing this, leave it in the block, as it falls to the bottom of the water jacket where it will pose minimal flow or cooling loss.Please Note: Most freeze plugs are lead coated brass and are non-magnetic & the freeze plug can block waterflow in the cylinder jacket (water flow will move it around more-so when driving) so I would not suggest leaving it in the block.


Where is the passenger's side rear freeze plug for a 2006 trailblazer?

The 2006 Chevy Trailblazer passenger side rear freeze plug is located near the back of the engine block. The freeze plug will be near the bottom of the engine block.


What is a better type of freeze plug?

The steel freeze plug is better than a brass freeze plug. This is because the steel freeze plug can withstand high temperature from the engine block. Moreover, the steel freeze plugs usually fit very well.


How do I install a block heater in the 4.9L 300 inline 6?

the block heater takes the place of your freeze plug, in this case you would need to locate and remove the correct freeze plug and replace it with the block heater plug, plug in the cord and route to appropriate location, done


Where in a 1998 5.7 Trans Am block is the drain plug?

There should be a drain plug on each side of the block by the freeze plugs.


What does a freeze plug control?

a freeze plug hole is where the sand is removed from your engine block or head when they were cast in a sand form. then the freeze plug itself is installed to seal those holes that are where liquid coolants now pass through the engine block and head .


Where is freeze plug on 2002 Nissan Pathfinder?

on the sides of the block


Were is the freeze plug on my 1994 ford mustang 302?

which freeze plug you want there are several. along both sides of block,at rear of block behind flywheel and also in both heads


Do you have to freeze a metal freeze plug?

No, they are just called that since they protect from damage if block freezes.