0
What else can I help you with?
Do you have to drain the coolant to replace the thermostat?
You will have to drain part of the coolant. Try to drain as little as possible and fill up before restarting the engine. No, the thermostat is usually at the top of the engine block (placed between the top input hose and the block). If, however, the radiator is full of coolant, there will be some spillage. Also, make sure the coolant has cooled down before replacement, and do periodically replace the coolant as needed.
How do you replace the engine coolant on a 1991 Honda Civic?
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
How d to flush coolant in Saturn vue?
drain radiator by unscrewing drain plug at bottom of radiator. drain fluid, close drain plug, fill with distilled water(in resivoir tank ) run till hot , turn on heater on high in car, drain water , repeat 3 times . last time add pure coolant it will mix with water in block for 50/50 % mixture. run and top off to full line on resivoir tank , check next few days make sure its on the full line marking on resivior tank.. Repeat every 4 years to be safe. " DRIVE LONG AND PROSPER"
2000 Monte Carlo low coolant light on intermittent coolant full runs good?
If coolant full could be a bad sensor
Does the radiator overflow reservoir need to be full for the heater to work in a Toy '94 4x4 pickup?
no it doesnt........the overflow container is just there to catch the extra coolant.......it has nothing to do with the heating system
How do you filling coolant?
Add coolant to the full cold line on the coolant reservoir when engine is cold.
How do you do a radiator flush in geo prizm?
To perform a radiator flush on a Geo Prizm, first ensure the engine is cool and then locate the drain valve at the bottom of the radiator to drain the old coolant into a container. Next, close the drain valve and fill the radiator with a flushing solution mixed with water, then run the engine for about 10-15 minutes with the heater on full to circulate the solution. Afterward, turn off the engine, let it cool, and drain the flushing solution completely. Finally, refill the radiator with fresh coolant and check for leaks.
Why does the low coolant light on a 2000 GMC Yukon when the coolant is full?
The coolant level sensor is bad
What is the correct coolant level for a 1999 Monte Carlo?
Radiator full and coolant recovery tank filled to mark Radiator full and coolant recovery tank filled to mark
How do you change coolant on astra 1.7td iszuzu engine?
im assuming this is the intercooled engine.... pull off the bottom water hose on the radiator drain coolant refit the hose top up the coolant via the expansion tank on the inner wing when it looks full( to the full mark on tank not full to the brim) start the engine and let it get warm so the thermostat opens and turn the interior heater on full and set the control to blow hot air then check the coolant level top up if nessesary rev the engine a few times if u have over filled it it will overflow..... dont worry bout it it will settle
Why does low coolant light come on when it is full?
maybe cuz its low on coolant
How much coolant do you put in a dirt bike?
you add coolant untill it is full ?
