Is a Curing Press where the Green Tire is cured, with steam heat , some use a combination of steam and nitrogen. is where the green tire becomes a Tire, and it takes the final shape with all the mandatory information the tire has on the sides.
Because the moulding process is conducted under high temperature. Cold-water curing 'freezes' the moulded tyre to it's current shape.
The max press for the tire will be written on the side of the tire. The vehicles recommended tire press will be on the label on the drivers door jamb.
The manufacturing process of tires industries is to mix the compounds, prepare the components, build the tire, curing and then the final finish.
To check your bike tire pressure without a gauge, you can use your thumb to press on the tire. If it feels firm and you can't easily press it in, the tire is likely properly inflated. If it feels too soft and you can press it in easily, the tire may need more air.
Tire manufacturing goes through a lot of process == Blending, Milling, Building and Curing. Curing tires, or the final step in molding the shape of the tires, takes 24 hours the least. So it's clear that tire creation would take at least 2 day or more to finish.
Air the tire back up to recommended press.
For a passenger car it takes about 25 minutes to manufacture 1 tire. This includes both vulcanization and curing processes. For larger off-road or truck tires it could take up to 24 hours or longer to produce a single tire. Its the curing process that takes the most time. The vulcanizing process only takes 10 minutes for a passenger car tire but increases by some minute the larger the size of the tire.
You need to click the left tire and press the valve.
Press the pin in the centre of valve.
To release air from a bike tire, you need to press the small valve stem located on the inner tube of the tire. This will allow the air to escape from the tire.
You should inflate the tire to the pressure recommended on the label on the drivers door jamb of the vehicle, not the max press on the tire.
To deflate a bike tire, you need to remove the valve cap and press down on the valve stem to release the air inside the tire.