Usually measures the distance travelled for a designated trip. It also calculates the gas mileage based on the amount of gas used for the mileage driven. Many can also keep track of round trip inforamtion by pushing a button once yu arrived at a destination,. So therefore it has a sub-trip (or dual trip counters)
where is the fuse for the trip computer on a 2001 gran prix
To reset the trip computer in a Mazda RX-8, turn on the ignition without starting the engine. Locate the trip computer button on the dashboard or steering wheel; it may be labeled "Trip" or "Reset." Press and hold this button until the display resets to zero. Release the button, and the trip computer should now be reset.
There is a fuse in the back of the trip computer that needs to be replaced
Hold the trip button down for 5 seconds and kilometers will switch to miles along with Celsius to Fahrenheit on trip computer display.
A huge computer in a museum in Hunsfield, Germany, claimed to be the first computer on my trip to Germany.
To warn you that there might be ICE on the roads To warn you that there might be ICE on the roads
Take your car to your dealer and they will replace the trip computer for free under the warranty-- they did it for me
it's possible to change trip computer display for navigation system in Acura MDX 2002?
Push the pin on the odometer in and hold set to trip record first
To fix the trip computer on an Acura MDX, start by checking the vehicle's battery and fuses, as electrical issues can affect the trip computer's functionality. If the display is not working, try resetting the trip computer by holding down the reset button on the instrument cluster. If these steps don’t resolve the issue, consult the owner's manual for specific troubleshooting tips or consider visiting a certified mechanic for a diagnostic check.
The possible cause is that the light bulbs have burned out. You have to remove the entire dash facing to access the computer. The facing is removed by gently pulling on it. It will pop off and allow access to the screws holding the trip computer in place. Remove the trip computer carefully and remove the bulbs by turning them out. Hope this helps
The fitted CD player has a CAN-Bus interface built in for remote control and speed volume adjust. If a third party CD/Radio is fitted, these functions are lost, along with the trip computer. It will not damage the trip computer.