answersLogoWhite

0

Two spark plugs helped in igniting the fuel from two directions rather then causing the voltage to be increased sufficiently to jump a small gap.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What purpose does the ignition coil serve?

The ignition coil increases the voltage to the spark plugs. Without this increase in voltage the spark would not be formed in the gap of the spark plug as it would not have enough voltage to jump from one electrode to the other. All spark plugs have two electrodes, a positive in the center of the plug, surrounded by a ceramic insulator and connected to the coil through a distributor, and the negative attached to the screw threads of the plug and grounded to the engine block to complete the electrical circuit.


How to change rear spark plugs in a 2005 Toyota sienna?

use the spark plug wrench and use used mirror to find the rear spark plug, you need to two person to do this, then fell the spark plug rear with your hands then apply the spark wrench to remove the old spark plug.


How do you check if the coil is operating on a Honda CRF 230?

Put the bike in neutral gear and switch the ignition on. Remove the spark plug from the cylinder head. Hold the spark plug against the engine so metal touches metal. Crabk the engine. If you see sparks in the spark plug head, then the coil is at least operating. If there is no spark, the spark plug itself may be defective. The spark plug cap may also be defective, try to change this. Check the earthing point of the coil, is it loose or not properly connected? Check if the battery is fully charged. The coil can fail in two ways, its voltage may be too low or none at all. The voltage at the coil as measured by a multimeter should be 70 Volts up to a 100 Volts. You have to change the coil if you have ruled out other things, such as a weak battery, loose connection, a bad spark plug or a defective spark plug cap.


What does a spark plug do?

A electrical charge from the coil goes through the spark plug wire to the plug were the plug turns it into a arc between the two contacts on the bottom of the plug. that arc ignites the fuel in the cylinder.


What is the size socket is used to change the 2000 Subaru Impreza two point two liter spark plug?

Usually 5/8 inch spark plug socket.


Will the single spark plug EFI Suzuki SV650 CDI box fit the twin spark plug model?

No. They are two completely different units.


What is the spark plug gap for a ford 302 1971?

fordparts.com shows .035 inch for two spark plug numbers and .030 inch for another spark plug number ( I believe the .030 inch is for heavy duty use )


What is the spark plug gap for a 1971 ford F100 302?

fordparts.com shows .035 inch for two spark plug numbers and .030 inch for another spark plug number ( I believe the .030 inch is for heavy duty use )


How do you change sparkplugs on a 2006 Chevy aveo?

First you have to remove the cylinder head cover. You can do this by removing the two hex screws on top. Once those screws are removed, pull the cover off. You will now see a bunch of spark plug wires on top. Pull one of the spark plug wires off, and at the very bottom, you will see your spark plug. Get your Spark Plug Socket, Long Extention, and a rachet and unscrew it and pull out. Once it is out, look at the spark plug for any signs of unusual wear. Get your new spark plug out of the box. Gap that little metal space at the top of the spark plug to what the owners manual says the spark plug gap should be between. Place anti-sieze on the threads of the spark plug and install them in reverse order.It is best to do one spark plug at a time so that you do not mix up the spark plug wires.


Should minors be give two wheelers to drive?

no minors should not be given two wheelers to drive


What is the coil to the spark pug called on a Yamaha ef600?

The coil to the spark plug is called an ignition coil on a Yamaha EF600. It is also referred to as the spark coil. These two terms are used for any coil to the spark plug in a vehicle.


How do you change spark plugs on a 2003 Mazda protege?

with a 10mm socket remove the two ignition coils and the two spark plug wires, using a 5/8 spark plug socket and one long extension and a ratchet remove the spark plugs and install the new ones