17 bolts. The pan is symetrical left to right and mostly rectangular except for the rear corners which have a rounded indentation.
13 mm
4l60e deep or shallow pan, or 4l80e, (depending on the bolt pattern on bottom of tranny, auto zone can tell u the bolt patterns to what tranny)
bolt pattern for what , head, transmission paqn, oil pan ?
The transmission solenoid on a 1997 4l80e is located at the bottom of the valve body. If you want to get to it, you would have to remove the tranny pan.
17 bolt pan = 4L80 transmission 16 bolt pan = 4L60 transmission
Well it would all depend on what bolt pattern you need. Tires? Rear end? Seats? Transmission pan? Oil Pan? Manifold? Bellhousing?
Bolt pattern for WHAT ? - Engine oil pan, transmission pan, cylinder head etc ? Give us some real information not just a misleading hint.
The 2000 Nissan Maxima transmission pan bolt torque specification is 60 pounds. The transmission pan bolt should be torqued in 30 pound intervals.
If it is an automatic transmission, plug is on pan, 17mm bolt on left side of pan.
To change the shift solenoid in a 4L80E transmission, start by disconnecting the negative battery terminal and draining the transmission fluid. Remove the transmission pan and filter to access the solenoids, then unscrew the retaining bolts to take out the old solenoid. Install the new solenoid in the same position, reassemble the pan and filter, refill the transmission with fluid, and reconnect the battery. Finally, check for proper operation and ensure there are no leaks.
The transmission pressure switch on a 2002 Chevy 2500HD with a 6.0L engine and a 4L80E transmission is typically located on the driver’s side of the transmission, near the back. It is mounted on the valve body and may require the removal of the transmission pan or filter to access it. Always consult the vehicle's service manual for specific details and procedures.
under the engine just before the transmission pan. you will know it by the draining bolt on the side of the pan. only one bolt. Its a large pan