Best Answer

if it's a 3.0 the exhaust manifold torque is 15-22 ft.lbs. if it's a 2.3 it is done in 2 steps: 1) 5-7 ft. lbs. 2) 20-30 ft. lbs.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the bolt torque in foot pounds for the exhaust manifold of a 1992 Ford Tempo?
Write your answer...
Still have questions?
magnify glass
Related questions

Where is the location of the O2 sensor for a 1988 Ford Tempo?

02 sensor is either in exhaust manifold, or in exhaust pipe between manifold and muffler

Where is the oxygen sensor on a 1987 Ford Tempo?

your oxygen sensor should be located on your exhaust manifold or on the exhaust pipe near the exhaust manifold, Make sure your engine is cool before placing your hands on the exhaust manifold, It can be very hot!

What are the head torque specs on a 1989 ford tempo 4 cylinder?

First start from middle out. 32 foot pounds. then repeat with 64 foot ponds.

What causes fume-like smells inside a Ford Tempo?

Leak in exhaust system?

What is the spark plug torque setting on a 1993 Ford Tempo?

The spark plug torque spec range is between 6 and 10 ft/lbs.

Torque specs on transaxle nut for 1990 Ford Tempo?

If you mean the nuts holding the axle/bearing assembly, I believe they should be torqued to 230 foot-pounds, or one 160 pound person standing (not jumping) on the arm of the wrench 1.4375 feet from the center.

How much does a 1992 Ford Tempo weigh?

The curb weight of 1992 Ford Tempo is 2,600 pounds. This car is 68.3 inches in width and 177 inches in length.

What is the torque and tightening sequence for the valve cover gasket for a 1992 for tempo 4 cylinder?

Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .

Can the passive shoulder belt on a 1991 Ford Tempo be unlatched?

no you will have to use a torque head bit and possibley a impact driver depending on how tight it is.

When is tempo going to get out of jail?

tempo was sentenced in 2002 for 24 years.he was a "drug dealer"bad boy!!!

How much does a 1990 Ford Tempo weigh?

The 1990 Ford Tempo base sedan has a curb weight of 2,587 pounds. The base sedan came with a 2.3 liter, 4-cylinder engine, and had a 3-speed automatic transmission.

What would cause the 1988 ford tempo 4 cylinder to run rich and make exhaust to get very hot?

Check the coil pack, sparkplugs and sparkplug wires. if their not all firing, you might have un-burnt gas, Burning in the exhaust. causing your car to run rich.