answersLogoWhite

0

What else can I help you with?

Related Questions

S-200 toro snowblower where is the throttle adjustment located?

On the S-200 Toro snowblower, the throttle adjustment is typically located on the control panel, near the handle. It may be a lever or a dial that allows you to adjust the engine speed. Consult the owner's manual for specific details and diagrams related to your model for precise instructions.


Spark plug for Toro S-200 snowblower?

You will need a Champion RJ18YC/130-435 spark plug. Gap it to .30. You can buy them here: http://www.jsesc.com/


What is the proper fuel oil mixture for a 1984 Yamaha IT 200?

The 1984 model, 200 hp Yamaha requires a 50:1 ratio.


How do i remove a spark plug from toro s-200 snowblower?

You have to remove the top plastic cover. There are screw heads inside the the propeller area and then two on each side. You will have to remove the gas cap also to get the cowl or cover off. You will be able to see and remove the spark plug.


Toro s 200 spark plug gap?

.30 gap


200 Johnson 130 hp fuel oil mixture?

The recommended fuel/oil ratio for a 200 Johnson 130 horsepower outboard engine is 50:1. This ratio should always be used or engine damage can occur.


What is the proper fuel mixture for a 1988 Yamaha 200 blaster?

32 to 1 which is one gallon of gas to 4 onces of oil


What is the correct fuel oil mix for a Yamaha yfm 200 ATV?

i have a 1985 Yamaha yfm 200, it is gas, no fuel/oil mix needed. just put in 93 octane. unless u have a 2 stroke then its usually a 50:1 or 40:1 mixture


Where can one purchase a Toro snow blower?

One can purchase a Toro snow blower from Home Depot where they have many available to buy for prices between $200 and $2,000. One can also buy them from Amazon.


What is the correct Echo pb 200 gas to oil mixture?

50/1 mixture


What kind of fuel does the 2014 Chrysler 200 use?

The 2014 Chrysler 200 runs on flex-fuel (FFV).


Where is fuel filter 200 series landcruiser?

After resetting the fuel light on a 200 series do you have to drain the filter or do anything else?