At idle 13-20 psi
With key on engine off 23-31 psi
big and hard
what is the correct psi for a 1994 land cruiser?
it needs a tune up
To load Freon into a 1994 Toyota Land Cruiser, locate the low-pressure service port, which is typically found on the larger diameter aluminum line between the evaporator and compressor. This port is usually near the engine compartment. Make sure to use the appropriate refrigerant type (often R-134a) and follow safety precautions, ensuring the system is off before connecting the recharge kit. Always check for leaks and confirm proper pressure levels after recharging.
Answer to your question is..... Trailer with brakes is 2500 kgs, 750 kgs unbraked, assuming it's an 80 series.
If it is a 3.1 9-13 psi.
On a 1994 KZJ78 or KZJ70 the ECU is behind the glove box. Remove the glove box inner and look up.
9 to 13 LBS. NO higher are lower.
YES coz i have a Toyota Corolla Sedan 1994.
To install an expansion valve on a 1994 Toyota Land Cruiser, first, ensure the A/C system is fully discharged. Remove the A/C lines connected to the old expansion valve, then detach the valve itself from its mounting location. Install the new expansion valve by securing it in place and reattaching the A/C lines, ensuring all connections are tight to prevent leaks. Finally, recharge the A/C system and check for proper operation.
My 1994 Toyota Celica has a power antenna.
No brake fluid, leaking slave cylinders or Master cylinder, replace seals or whole unit and then bleed total braking system