function of static relay
function of static relay
current relay are using for over current low state & high state.but potential relay are related to voltage.
The voltage for a potential relay will depend on the circuit that the relay is installed in. The relay can be made for low voltages (5v) to higher voltages (440.)
relay centre
OFFSET IMPEDANCE RELAYOffset impedance relay is also known under names ADMITTANCE RELAY or MHO RELAY
The potential can be calculated from the wave function using the Schrödinger equation, where the potential energy operator acts on the wave function. This involves solving the time-independent Schrödinger equation to find the potential energy function that corresponds to the given wave function. The potential can be obtained by isolating the potential energy term on one side of the equation.
Common wire of the potential relay goes to the compressor contactor. (5) Start wire of the potential relay goes to compressor run capacitor. (2) Run wire of the potential relay goes to the start capacitor. (1)
Potential or voltage relay is used for assisting the motor to start. Its operation is based on the increase in back-electro-motive force (back-EMF).
Basically, a "relay" is a switch. When you push the horn button you're triggering the relay which in turn feeds power to the horn.
There is no such thing as a SMT relay. An SMTP relay, on the other hand, stands for Simple Mail Transfer Protocol. The function of a SMTP is to transfer email messages across two servers of Internet Protocol networks.
you can take thin wires up to a relay then run thicker wires to lights or do you mean a bulb fail relay.