There are three ways to find a gear ratio.
1 A dealer can normally tell from the vin number.
2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement
info.
3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires.
more than likely it's a 3.08 gear in the rearend.
Most likely a 2.29:1 ratio
you have to change the ring and pinon gars
The gear ratio in a 1986 Monte Carlo SS typically varies depending on the specific rear axle option. Most commonly, it came with a 3.42:1 gear ratio in the 10-bolt rear axle. However, some versions might have had different ratios, so it's essential to verify the specific configuration of the vehicle in question.
check the transmission linkage to be sure it didn't come off or break.
The speed sensor on a 1984 Monte Carlo is located on the output shaft. The speed sensor is typically driven by the gear of the vehicle.
4t65e with 2.86 gear ratio and 4RDB,3RDB ON ID. TAG.2003-2004 monte carlo,impala with 3.4 engine.
There are four ways to find a ratio. 1 A dealer can normally tell from the vin number. 2 There are normally tags or labels on the axle that have part number, gear ratio, and fluid requirement info. 3 You can count how many times you have to turn the driveshaft to get one complete turn of the tires. 4 You can divide the number of teeth on the ring gear and divide by number of teeth on the pinion.
Transmission temp switch is most likely cause.
yes, they do on my 02.
Yes, most montes in 85 had the column gear shift.
It keeps the car from starting in gear. The starter will only engage in park or neutral.